Results 111 to 120 of about 560,457 (289)
Laser‐Induced Graphene from Waste Almond Shells
Advanced Functional Materials, EarlyView.Almond shells, an abundant agricultural by‐product, are repurposed to create a fully bioderived almond shell/chitosan composite (ASC) degradable in soil. ASC is converted into laser‐induced graphene (LIG) by laser scribing and proposed as a substrate for transient electronics.
Yulia Steksova +9 more
wiley +1 more source
Advanced Functional Materials, EarlyView.Ferroelectric tunnel junction devices based on epitaxial undoped ferroelectric HfO2 films demonstrate stable switching endurance of over 106 switching cycles, low write voltages of ±3 V, 16 measured resistance states, and neuromorphic capability.
Markus Hellenbrand +13 more
wiley +1 more source
Advances in Sustainable and Wearable Textile Based Soft Robotics
Advanced Functional Materials, EarlyView.This Review examines advances in wearable textile‐based soft robotics, focusing on sustainable materials, integrated sensing, and scalable actuation. It discusses manufacturing and system integration across healthcare, assistive robotics, prosthetics, and human–machine interfaces, and highlights key challenges in circular design, including life‐cycle ...
Zahir Abbas +6 more
wiley +1 more source
Frontiers in Physics, 2016 Gas flow heating using radio frequency plasmas offers the possibility of depositing power in the centre of the flow rather than on the outside, as is the case with electro-thermal systems where thermal wall losses lower efficiency.
Christine eCharles +4 more
doaj +1 more source
Advanced Functional Materials, EarlyView.A dynamically actuated reconfigurable topographical surface (DARTS) integrates contact‐mediated bactericidal nanotopography with programmable mechanical actuation to actively disrupt bacterial biofilms. Dynamic surface reconfiguration enhances bacterial killing and suppresses implant‐associated infections in vivo, providing a new strategy for active ...
Mohammad Asadi Tokmedash +4 more
wiley +1 more source
A Study of Impulse Voltage Generator for Testing Low Voltage System [PDF]
This study designs impulse voltage generator of 6 kV ,1.2/50 μs for testing low voltage electrical equipment according to IEC 60439 standard. This impulse generator is used to test conductor bar mate-rial in 3 Phase 4 Wire 400V.
W, Boonpha +5 more
core +2 more sources
Advanced Functional Materials, EarlyView.A gradient‐engineered all‐paper sensor is fabricated by integrating MXene and in situ grown AgNPs within hierarchical cellulose networks. The device breaks the sensitivity–detection range trade‐off through cascaded conductive pathways, enabling ultrahigh pressure sensitivity, humidity–pressure decoupled dual‐mode sensing, and outstanding EMI shielding,
Ao Li +7 more
wiley +1 more source
Advanced Functional Materials, EarlyView.The physical realization of artificial neurons is a critical challenge for energy‐efficient neuromorphic computing. This review presents a comprehensive analysis of the evolution of artificial neuron implementations from conventional CMOS to emerging post‐CMOS technologies.
Kannan Udaya Mohanan +4 more
wiley +1 more source
Advanced Functional Materials, EarlyView.This study advances SafeWax, a bio‐inspired, fatty‐acids‐based superhydrophobic coating, by identifying an agriculturally compliant solvent and revealing how solvent‐controlled Fatty acid crystallization governs the coating's microscopic structure and performance.
Niv Ben‐Arie +13 more
wiley +1 more source
Characteristics of the impulse generator depending on the load type
, 2016 During practical measurements with the impulse generator, time parameters of the lightning-impulse voltage can be affected by test object’s parameters like high capacitance.
Veisheipl, Karel
core