Results 61 to 70 of about 760 (176)
Applied SciencesAlloy 800H stands as one of the few code-qualified materials for fabricating in-core and out-of-core components operating in high-temperature reactors.
Wenjing Li +5 more
doaj +1 more source
Journal of Engineering, Volume 2026, Issue 1, 2026.The manufacturing industry increasingly relies on laser metal deposition (LMD) for gear repair and manufacturing. This paper studies the repair process of a gear tooth, starting with the design and milling of a groove that serves as the substrate to rebuild the tooth.
Igor Ortiz +5 more
wiley +1 more source
Frontiers in MaterialsThis study introduces an Inconel 625 interlayer to overcome the inherent incompatibility between Ti-6Al-4V titanium alloy and 304 stainless steel during rotary friction welding.
Rui Tang, Rui Tang, Chunquan Li
doaj +1 more source
Erosive Wear of Inconel 625 Alloy Coatings Deposited by CMT Method
Archives of Metallurgy and Materials, 2016 Abstract The article presents the investigation results concerning the determination of the characteristics of erosive wear caused by the impact of Al2O3 solid particles on the surface of Inconel 625 alloy after plastic working and the same material after weld cladding process using the CMT method.
Solecka M. +4 more
openaire +2 more sources
Advanced Engineering Materials, Volume 27, Issue 24, December 2025.Ni‐base superalloys produced using additive manufacturing (AM) have a different response to heat treatments when compared to their conventional counterparts. Due to such unpredictability, various alloys with industrial interest are currently overlooked in most prior AM research.
Guilherme Maziero Volpato +6 more
wiley +1 more source
Journal of Materials Research and TechnologyAnnealing twin boundaries (ATBs) are low-energy grain boundaries (GBs) that play a key role in markedly enhancing the mechanical properties and stress corrosion resistance of Inconel 625 seamless tube.
Yubi Gao +6 more
doaj +1 more source
Metals, 2019 Inconel 625 and steel P355NH were bonded by explosive welding in this study. Explosively welded bimetal clad-plate was subjected to the two separated post-weld heat treatment processes: stress relief annealing (at 620 °C for 90 min) and normalizing (
Robert Kosturek +3 more
doaj +1 more source
Advanced Engineering Materials, Volume 27, Issue 24, December 2025.The utilization of direct energy deposition (DED)‐arc additive manufacturing processes in industrial applications is increasing, and these processes have the potential for multi‐material applications. This work provides a overview of the state of research in DED‐arc made functional graded structures, to establish a link to potential industrial ...
Kai Treutler, Volker Wesling
wiley +1 more source
Corrosion analysis of HSLA-80/Inconel-625 dissimilar weldments
Results in EngineeringHSLA-80 steel is commonly used in marine applications due to its superior strength, toughness, good weldability, and atmospheric corrosion resistance. Inconel-625 alloy, which exhibits outstanding corrosion resistance and high-temperature strength, is a ...
Han-Sheng Huang +2 more
doaj +1 more source
Journal of Materials Research and TechnologyThis study explores the laser wire direct energy deposition (LW-DED) process to manufacture bimetallic SS316L and Inconel 625 alloy. The microstructure and mechanical properties of as-printed SS316L, Inconel 625, and the bimetal were analyzed.
Shivank Tyagi +3 more
doaj +1 more source