Results 241 to 250 of about 9,866 (290)

Correlative Electron Paramagnetic Resonance Imaging and Atomic Force Microscopy of Lithium Deposited on Copper

ChemPhysChem, Volume 26, Issue 6, March 15, 2025.
The correlation of a spectroscopic (EPRI) and microscopic (AFM) technique is demonstrated for a sample of Li deposited on Cu. Areas of different morphology were analysed. The techniques complement each other's length scales as well as the information obtained from the sample.
Beatrice Wolff, Christian Hellenbrandt, Peter Jakes, Rüdiger‐A. Eichel, Josef Granwehr, Florian Hausen   +5 more
wiley   +1 more source

Atomic force microscope protocols for characterising the elastoviscoplastic biomechanical properties of corneocytes. [PDF]

Commun Biol
Évora AS, Zhang Z, Johnson SA, Zhang Z, Adams MJ.   +4 more
europepmc   +1 more source

Microscopic time‐dependent mechanical behavior of shale derived from nanoindentation

Deep Underground Science and Engineering, EarlyView.
This study conducted grid nanoindentation creep tests to systematically analyze the microscopic creep behaviors of shale. Based on the analysis of creep strain rate sensitivity, the primary mechanism of microscopic creep in shale was found to be the extension and closure of microcracks.
Cunbao Li, Shilei Zhong, Heping Xie, Changtai Zhou, Jianjun Hu   +4 more
wiley   +1 more source

Understanding the Nanoindentation Edge Effect of Single-Crystal Silicon Using Molecular Dynamics Simulations. [PDF]

Micromachines (Basel)
Long C, Li R, Zhao P, Li Z, Kang S, Li D, Liu H.   +6 more
europepmc   +1 more source

Strain‐based modeling and analysis for rock blasting and geomechanics applications

Deep Underground Science and Engineering, EarlyView.
This paper introduces a novel strain‐based modeling approach for blasting and geomechanical applications, using measurable variables like particle velocity, strain, and displacement. By bypassing complex constitutive relations, strain‐based models capture critical blasting trends and full‐blast design parameters with minimal calibration.
Ruilin Yang
wiley   +1 more source

Nanoscale Characterization of Nanomaterial-Based Systems: Mechanisms, Experimental Methods, and Challenges in Probing Corrosion, Mechanical, and Tribological Properties. [PDF]

Nanomaterials (Basel)
Hoque MA, Yao CW.
europepmc   +1 more source

Failure characteristics and the energy criterion of rock with a through‐going joint under true‐triaxial unloading conditions: Insights from the DEM model

Deep Underground Science and Engineering, EarlyView.
The rock failure mode is significantly influenced by the contributing factors, such as the joint inclination, the initial confining pressure, and the unloading point. We found six typical rock failure modes after a large number of numerical tests. Abstract Excavation unloading damages rock masses, with preferential failure along geological defects in ...
Fei Liu, Changhui Liang, Sijia Liu, Yongjun Zhang, Luo Wang   +4 more
wiley   +1 more source

Design and development of a novel polymer coating system with exceptional creep resistance. [PDF]

Npj Mater Sustain
Ameli N, Verma J, Irungu BM, Aliasghari S, Shishkin A, Matthews A, Goel S.   +6 more
europepmc   +1 more source

Diffusion-Plating Al₂O₃ Film for Friction and Corrosion Protection of Marine Sensors. [PDF]

Micromachines (Basel)
Liu Y, Li L, Wei D, Xu K, Liu L, Li L, Wu Z.   +6 more
europepmc   +1 more source

Oxygen vacancy-induced strengthening and toughening in (K,Na)NbO₃-based piezoceramics revealed via nanoindentation. [PDF]

Nat Commun
Zhang Z, Yang B, Chen L, Zhang Z, Guo J.
europepmc   +1 more source