Results 71 to 80 of about 81,418 (355)
Sensors, 2021 By combining results of adsorption/desorption measurements on powders and electrical conductivity studies on thick and thin films, the interaction of indium tin oxide with various ambient gas species and carbon monoxide as potential target gas was ...
Stefan Dietrich +3 more
doaj +1 more source
Advanced Functional Materials, EarlyView.Shellac, a centuries‐old natural resin, is reimagined as a green material for flexible electronics. When combined with silver nanowires, shellac films deliver transparency, conductivity, and stability against humidity. These results position shellac as a sustainable alternative to synthetic polymers for transparent conductors in next‐generation ...
Rahaf Nafez Hussein +4 more
wiley +1 more source
Advanced Functional Materials, EarlyView.This study presents the BioCLEAR system, a highly transparent and conductive neural electrode array composed of silver nanowires (AgNWs) and doped PEDOT:PSS, enabling neural recordings with minimal optical artifacts. When integrated with a GRIN lens, this cost‐effective neural implant allows simultaneous electrophysiological recording and GCaMP6‐based ...
Dongjun Han +17 more
wiley +1 more source
Experimental study on the reliability of water/fluoropolymer/ITO contact in electrowetting displays
Results in Physics, 2019 The practicability of using DI water in electrowetting displays with a thick layer of fluoropolymer and the reliability of water/fluoropolymer/indium tin oxide contact was investigated experimentally.
Rui Zhou +5 more
doaj +1 more source
Effect of sintering temperature and heat treatment on electrical properties of indium oxide based ceramics [PDF]
, 2008 Indium oxide based ceramics with bismuth oxide addition were sintered in air in the temperature range 800-1300 ºC. Current-voltage characteristics of In2O3-Bi2O3 ceramics sintered at different temperatures are weakly nonlinear.
Bondarchuk, AN +5 more
core
Advanced Functional Materials, EarlyView.A frequency‐tunable ferroelectric synaptic transistor based on a buried‐gate InGaZnO channel and Al2O3/HfO2 dielectric stack exhibits linear and reversible weight updates using single‐polarity pulses. By switching between ferroelectric and trap‐assisted modes depending on input frequency, the device simplifies neuromorphic circuit design and achieves ...
Ojun Kwon +8 more
wiley +1 more source
The Effects of Oxygen Content, Deposition Rate and Annealing Towards Thin Film of Indium Tin Oxide
Jurnal Ilmu Dasar, 2012 Indiun tin oxide is one of the materials that has physical properties, rarely seen in other materials. Indium tin oxide properties have the main role in developing the technology of thin film shown through its properties.
Muslimin Muslimin
doaj
Nanopatterned metallic transparent electrodes for the near-infrared spectrum
AIP Advances, 2021 Near-infrared transparent electrodes constitute an essential component of light-emitting and photovoltaic devices widely employed in short- and long-range communication, light detection and ranging, biodiagnostics, security, virtual and augmented reality,
Aliaksandr Hubarevich +4 more
doaj +1 more source
Indium Tin Oxide/Barium Strontium Titanate THz Sensor Antenna
, 2018 A Bow-Tie ITO/BST and Au/BST antennas were designed and analyzed using the finite element, Multiphysics COMSOL program. The study shows that the outputs peak at several modes and ITO antennas allow for the integration of the antenna with optoelectronic ...
Abdel-Motaleb, Ibrahim, Dittakavi, Sai
core +1 more source
Advanced Functional Materials, EarlyView.A rationally engineered bifunctional photocatalyst is reported, which achieves simultaneous selective oxidation of biomass‐derived 5‐hydroxymethylfurfural (HMF) to 2,5‐diformylfuran (DFF) and efficient H2 evolution. By precisely positioning Au and Co3O4 on Zn3In2S6 nanosheet, dual interfacial electric fields are well constructed to spatially separate ...
Shiqing Li +8 more
wiley +1 more source