Results 21 to 30 of about 418,583 (275)
, 2008 The use of a copper-squirrel cage in induction motors has been analyzed testing a prototype rated 1.1 kW and comparing the performances with a twin machine with an aluminum cage. The comparison has been made using torque, efficiency, starting torque, and
Boglietti, Aldo +3 more
core +1 more source
Transient System Model for the Analysis of Structural Dynamic Interactions of Electric Drivetrains
Energies, 2021 In electric drivetrains, the traction machines are often coupled to a gear transmission. For the noise and vibration analysis of such systems, linearised system models in the frequency domain are commonly used.
Marius Franck +4 more
doaj +1 more source
Discussion on "AC Drive Observability Analysis" [PDF]
, 2015 In the paper by Vaclavek et al. (IEEE Trans. Ind. Electron., vol. 60, no. 8, pp. 3047-3059, Aug. 2013), the local observability of both induction machine and permanent-magnet synchronous machine (PMSM) under motion-sensorless operation is studied.
Duc, Gilles +3 more
core +3 more sources
Continuous Control Set Predictive Current Control for Induction Machine
Applied Sciences, 2021 A speed tracking control method for induction machine is shown in this paper. The method consists of outer speed control loop and inner current control loop. Model predictive current control method without the need for calculation of the weighing factors
Toni Varga +3 more
doaj +1 more source
Field-weakening performance of interior permanent-magnet motors [PDF]
, 2002 Copyright © 2002 IEEEThis paper compares the field-weakening performance under rated and overload conditions of synchronous reluctance and interior permanent-magnet motors against that of a baseline 2.2-kW induction machine.
Ertugrul, N., Soong, W.
core +1 more source
A Critical Review of Emerging Technologies for Electric and Hybrid Vehicles
IEEE Open Journal of Vehicular Technology, 2021 Emerging topics such asenvironmental protection and energy utilization have pushed research and development of electric vehicles and hybrid electricvehicles (EVs/HEVs).
Christopher H. T. Lee +4 more
doaj +1 more source
Speed sensorless field oriented control of ac induction motor using model reference adaptive system [PDF]
, 2020 In order implement the vector control technique, the motor speed information is required. Incremental encoder, resolvers and tachogenerator, are used to reveal the speed.
Ismael, Ahmed Jameel
core
IEEE AccessThe development of the novel multiphase brushless doubly-fed generator system and voltage controller for stand-alone mode configuration is proposed in this paper.
Krzysztof Blecharz +2 more
doaj +1 more source
Impact of fractional filter in PI control loop applied to induction motor speed drive
Electrical engineering & Electromechanics, 2022 Introduction. One of the main problems of electrical machine control systems is to obtain a satisfactory performance in the rejection of load disturbances, as well as in the set-point tracking tasks.
S. Hassainia +3 more
doaj +1 more source
Advanced model of squirrel cage induction machine for broken rotor bars fault using multi indicators [PDF]
, 2016 Squirrel cage induction machine are the most commonly used electrical drives, but like any other machine, they are vulnerable to faults. Among the widespread failures of the induction machine there are rotor faults. This paper focuses on the detection of
Dahi, Khalid +4 more
core +2 more sources