Results 21 to 30 of about 170,221 (359)
Line-start permanent-magnet motor single-phase steady-state performance analysis [PDF]
, 2003 This paper describes an efficient calculating procedure for the steady-state operation of a single-phase line-start capacitor-run permanent-magnet motor.
Cossar, C. +6 more
core +1 more source
Application of Sensorless Sliding Mode Observer in Control of Induction Motor Drive
Advances in Electrical and Electronic Engineering, 2017 Induction motors are widely used in an industry and it is necessary to improve control methods for induction motors to increase the efficiency of them. In this paper, sliding mode controllers are proposed instead of traditional PI controllers in vector ...
Chau Si Thien Dong +4 more
doaj +1 more source
An Integral Battery Charger with Power Factor Correction for Electric Scooter [PDF]
, 2009 This paper presents an integral battery charger for an electric scooter with high voltage batteries and interior-permanent-magnet motor traction drive.
Armando, Eric Giacomo +2 more
core +2 more sources
Journal of Electrical Systems and Information Technology, 2017 An electric propulsion system is generally based on torque controlled electric drive and DC series motors are traditionally used for propulsion system.
Nisha G.K. +2 more
doaj +1 more source
A multi-level converter with a floating bridge for open-ended winding motor drive applications [PDF]
, 2016 This paper presents a dual three phase open end winding induction motor drive. The drive consists of a three phase induction machine with open stator phase windings and dual bridge inverter supplied from a single DC voltage source. To achieve multi-level
Chowdhury, Shajjad +3 more
core +1 more source
Improving reliability in electric drive systems during IGBT short‐circuit fault
IET Power Electronics, 2021 To improve the reliability of electric drive systems during the insulated‐gate bipolar transistor short‐circuit fault, a control method is proposed for Y‐connected 3‐phase induction motors.
Maryam Naghavi +3 more
doaj +1 more source
Mathematics, 2022 Induction motors are popularly used in various applications because of the proposed modest construction, substantiated process, and limited size of specific power. The traditional AC traction drives are experimentally analyzed.
Usha Sengamalai +7 more
doaj +1 more source
Artificial intelligence based direct torque control of induction motor drive system [PDF]
, 2020 In this project, a three-phase Induction motor (IM) under the direct torque control (DTC) technique is studied. IM is known for its simple engines and its self-starter feature but it always suffered a setback in the area of torque and speed control as it
Alhamin, Sarinah Binti +5 more
core
High Performance Multicell Series Inverter-Fed Induction Motor Drive [PDF]
, 2017 This document is the Accepted Manuscript version of the following article: M. Khodja, D. Rahiel, M. B. Benabdallah, H. Merabet Boulouiha, A. Allali, A. Chaker, and M.
A Ajami +27 more
core +2 more sources
Maximum Torque Control of 3-phase induction motor drives [PDF]
Archives of Electrical Engineering, 2018 Maximum Torque Control (MTC) is a new method applied for control of induction motor drives. The drive is controlled by dc voltage supplying a converter in the range below nominal speed and by a field that weakens for a speed range above the nominal speed.
Piotr Wach
doaj +1 more source