Results 61 to 70 of about 2,557,603 (314)
Advanced Engineering Materials, EarlyView.High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
Mokslas: Lietuvos Ateitis, 2016 The article deals with abandoned industrial buildings and lands conversion concept, objectives, problems, beneficial results of a successful conversion for urban expansion, as a complex process of sustainable development.
Miroslavas Pavlovskis +2 more
doaj +1 more source
Security warning system monitors up to fifteen remote areas simultaneously [PDF]
, 1966 Security warning system consisting of 15 television cameras is capable of monitoring several remote or unoccupied areas simultaneously. The system uses a commutator and decommutator, allowing time-multiplexed video transmission.
Fusco, R. C.
core +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.High‐frequency (HF) welding of steel is limited by oxide inclusions that degrade weld quality. This study demonstrates, for the first time, the integration of a nonthermal Ar/H2 dielectric barrier discharge (DBD) plasma jet into HF welding. Local plasma treatment provides effective shielding and in‐situ oxide reduction, resulting in markedly fewer and ...
Viktor Udachin +4 more
wiley +1 more source
Management Systems in Production Engineering, 2018 Many innovative environmental technologies never reach the market because they are new and cannot demonstrate a successful track record of previous applications. This fact is a serious obstacle on their way to the market.
Molenda Michał +1 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.A numerical–experimental framework is developed for characterizing multi‐matrix fiber‐reinforced polymers (MM‐FRPs) combining epoxy and polyurethane matrices. Harmonic bending tests are integrated with finite element model updating (FEMU) to simultaneously identify elastic and viscoelastic material parameters.
Rodrigo M. Dartora +4 more
wiley +1 more source
Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres
Advanced Engineering Materials, EarlyView.This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann +3 more
wiley +1 more source
INDUSTRIAL AREAS. A SURVEY, ANALYSIS AND APPRAISAL OF THE POTENTIAL FOR CONVERSION OF DISUSED INDUSTRIAL AREAS IN TICINO [PDF]
This research, promoted by the Università della Svizzera italiana, Accademia di architettura di Mendrisio, through i.CUP (Institute for the Contemporary Urban Project) laid the ground for establishing an observatory of industrial buildings that would ...
Enrico SASSI +3 more
core
Corn or Current? The Agro-Industrial Water Conflict [PDF]
, 2014 A new report shows where conflicts between industry and agriculture for limited water supplies could be most severe. MSCI ESG Research used data from WRI's Aqueduct Water Risk Atlas to evaluate agro-industrial water conflict for 110 publicly traded ...
core