Aceh International Journal of Science and TechnologyPhantoms are used to research image quality and the amount of attenuation as an organ simulation. If done in the human body, it would be hazardous. High radiation exposure can damage cells.
Mohtar Yunianto +2 more
doaj +1 more source
Pellet Printing for Soft Robotic Devices
Advanced Science, EarlyView.Fused Granulate Fabrication (FGF) is established here as a reliable method for fabricating soft, airtight robotic devices. Through coordinated optimization of hardware, material selection, and process parameters, this approach enables high‐speed printing of thermoplastic elastomers with silicone‐like softness and modulus.
Yijia Wu +6 more
wiley +1 more source
Influence of Infill Design in Fabrication of 3D-printed PLA Parts Using FDM
MedžiagotyraThe present work examines the mechanical characteristics of polylactic acid (PLA) samples manufactured in 3D printing using various infill patterns. The infill patterns investigated are cuboid, grid, and octet, prepared at a constant infill density of 50
Tamilanban THANGARAJU +6 more
doaj +1 more source
Fabrication of High‐Density Multimodal Neural Probes Based on Heterogeneously Integrated CMOS
Advanced Science, EarlyView.A chiplet‐based methodology democratizes active neural probe development on standard bulk CMOS services. This yields the first probe combining high‐density electrophysiology (416 electrodes) with calcium imaging (832 photodiodes) and complete on‐chip signal processing across 13 shanks.
Ju Hee Mun +10 more
wiley +1 more source
Examination of Low-Cyclic Fatigue Tests and Poisson's Ratio Depending on the Different Infill Density of Polylactide (PLA) Produced by the Fused Deposition Modeling Method. [PDF]
Polymers (Basel), 2023 Gaweł A +3 more
europepmc +1 more source
Strategically using public housing assets could transform our middle suburbs [PDF]
‘Greyfields’ in the Australian context have been defined as those ageing but occupied tracts of inner and middle ring suburbia that are physically, technologically and environmentally failing.
Shane Murray +9 more
core
EngAdditive manufacturing (AM) technologies are a key tool in producing complex and functional polymer parts, with Fused Deposition Modelling (FDM) emerging as the most widely used technique.
Jure Marijić +3 more
doaj +1 more source
3D investigation and modeling of the geometric effects on porosity in packed beds
AIChE Journal, EarlyView.Abstract In porous beds, physical boundaries restrict particle arrangement, leading to inhomogeneous porosity. This paper reports on the porosity profiles that are the result of geometric effects on monodisperse packed beds in cylindrical and cubic arrangements. Special focus is given to the influence of edges and corners in cubic geometries.
Bastian Oldach +3 more
wiley +1 more source
Multi-objective numerical optimization of 3D-printed polylactic acid bio-metamaterial based on topology, filling pattern, and infill density via fatigue lifetime and mass. [PDF]
PLoS One, 2023 Dadashi A, Azadi M.
europepmc +1 more source
Advanced Experiment Design Strategies for Drug Development
Advanced Intelligent Discovery, EarlyView.Wang et al. analyze 592 drug development studies published between 2020 and 2024 that applied design of experiments methodologies. The review surveys both classical and emerging approaches—including Bayesian optimization and active learning—and identifies a critical gap between advanced experimental strategies and their practical adoption in ...
Fanjin Wang +3 more
wiley +1 more source