Results 141 to 150 of about 975,679 (231)
Oil Sorption and Oil-Water Separation Using 3D Printed Sorbents Manufactured with Fused Filament Fabrication. [PDF]
Polymers (Basel)Kántor J, Gergely AL.
europepmc +1 more source
Earthquake Spectra, Volume 42, Issue 4, November 2026.Modern confined masonry (CM) construction consists of masonry walls confined by reinforced concrete (RC) tie‐columns and tie‐beams. When built correctly, CM buildings have shown good performance in earthquake's shaking. Even though CM construction has been practised for almost a century in some Latin American countries, its use and standardisation are ...
Ahsana Parammal Vatteri +23 more
wiley +1 more source
Effects of Infill Pattern and Infill Density on the Flexural Properties of Markforged Onyx. [PDF]
Polymers (Basel)Tran J, Shubella R, Hunt A.
europepmc +1 more source
New Results From the Pre‐Pottery Neolithic Site of Al Uyaynah, Tabuk, in Northwestern Saudi Arabia
Arabian Archaeology and Epigraphy, Volume 37, Issue 1, Page 182-206, November 2026.ABSTRACT Al Uyaynah is a low sandstone mound on an alluvial plain, long known for its extensive surface remains of stone‐built circular and rectangular structures. Following test excavations in 2012, more detailed excavation was undertaken in 2016 within one of the largest rectangular stone structures.
Khalid Alasmari +6 more
wiley +1 more source
Experimental and Numerical Investigations on Compressive Performance of Additively Manufactured PLA Structures with Various Infill Patterns. [PDF]
Polymers (Basel)Llidó Barragán A +4 more
europepmc +1 more source
Polymer Composites, Volume 47, Issue 19, Page 17501-17513, 10 October 2026.Integrated analytical framework for tensile response of additively manufactured polymer composites, supported by experimental validation. ABSTRACT Additive manufacturing (AM) enables innovative product development through its material versatility and design freedom, further enhanced by advanced materials such as composites.
Ozgur Poyraz, Abas Abasov
wiley +1 more source
Hybrid FFF-CNC Processing of PLA Fixtures with Gyroid Internal Structures. [PDF]
Materials (Basel)Franczyk E, Zębala W.
europepmc +1 more source
Journal of Applied Clinical Medical Physics, Volume 27, Issue 10, October 2026.Abstract Background Reference dosimetry for the GammaPod breast radiosurgery device is determined in a polymethyl methacrylate (PMMA) phantom, while the clinical dose calculations assume the patient's breast has the atomic composition of water with a density (∼0.935 g/cm3).
Stewart J. Becker +8 more
wiley +1 more source
Experimental and Statistical Evaluation of Infill Density Effects on the Mechanical Properties of FDM-Printed PLA, ABS, PC, and PETG Engineering Materials. [PDF]
Polymers (Basel)Akgümüş D.
europepmc +1 more source
Journal of Applied Clinical Medical Physics, Volume 27, Issue 10, October 2026.Abstract Background Testicular shielding has long been used to reduce testicular dose during radiation treatment. However, quantitative evaluations of the effectiveness of such shielding in the literature vary substantially. Purpose In this study, the dose reduction expected at both the testicular skin surface and the inside of the testes was evaluated
Joseph Speth +8 more
wiley +1 more source