Results 151 to 160 of about 12,003 (292)

Generalized EIS Measurement Method in Li-Ion Batteries. [PDF]

Sensors (Basel)
Nogales JM, Corbacho I, Romero-Galán F, Domínguez MÁ, Carrillo JM.   +4 more
europepmc   +1 more source

Flexoelectrically Induced Polar Topology in Twisted SrTiO3 Membranes

Advanced Materials, EarlyView.
Twisted SrTiO3 bilayers host polar vortices of flexoelectric origin, revealed through combined experiment and theory. By reconstructing polarization from the toroidal moment of strain gradients, the work establishes a 3D chiral state with broken inversion and mirror symmetries.
Isabel Tenreiro, Hugo Aramberri, Víctor Rouco, Gabriel Sánchez‐Santolino, Mariona Cabero, Fernando Gallego, David Sánchez‐Manzano, José M. González‐Calbet, Federico Mompeán, Mar García‐Hernández, Alberto Rivera‐Calzada, Jorge Íñiguez‐González, Carlos León, Jacobo Santamaría   +13 more
wiley   +1 more source

An Arduino-Based, Portable Prototype for the Recording and Analysis of EEG Signals to Support Self-Detection and Self-Monitoring of Stress. [PDF]

Sensors (Basel)
Baltzis S, Pagiatakis G, Voudoukis N, Papadakis A, Dritsas L, Uzunidis D.   +5 more
europepmc   +1 more source

Electrically Readable Lateral Flow Assay Using Organic Transistors for Diagnostic Applications

Advanced Materials, EarlyView.
Electrolyte‐gated organic field‐effect transistors (EGOFETs) are integrated with lateral flow (LF) paper fluidics to create a reusable, portable, and low‐cost point‐of‐care (PoC) diagnostic test. The devices are validated for Human Immunoglobulin G detection, achieving high sensitivity (0.1 fm), selectivity, and reproducibility with rapid results in 20–
María Jesús Ortiz‐Aguayo, Carme Martínez‐Domingo, Diego Gutiérrez, Dean Kos, Marta Mas‐Torrent   +4 more
wiley   +1 more source

Design of a 40nm CMOS instrumentation amplifier for biomedical applications

This project explores using the differential difference amplifier (DDA) architecture to design an instrumentation amplifier that can be used in biomedical applications.
Tan, Lucas Wen Yu
core  

Anisotropic Magnetoresistive Sensors: Dynamic Modeling and Characterization for Blade Tip-Timing Measurements. [PDF]

Sensors (Basel)
Busti D, Capponi L, Gaspari A, Fabbiano L, Rossi G.   +4 more
europepmc   +1 more source

Tough, Ductile, and Strong Hard‐Soft Cementitious Composite Enabled by Multi‐Material Additive Manufacturing

Advanced Materials, EarlyView.
Drawing inspiration from the layered hard‐soft architecture found in sea sponges, this work establishes a new framework for architected cementitious composites (ACC) through multi‐material additive manufacturing (MMAM) process. The integration of mortar and elastomer phases into layered architectures enables synergistic toughening mechanisms, including
Aimane Najmeddine, Shashank Gupta, William Makinen, Zayvinn Lin, Krystal Delnoce, Reza Moini   +5 more
wiley   +1 more source

Polymorph‐Specific Electronic Transduction in WO3 during Molecular Sensing

Advanced Materials, EarlyView.
Metal‐oxide polymorphs with similar surface chemistry can nevertheless exhibit distinct sensing properties. In γ‐ and ε‐WO3, analyte adsorption appears comparable; yet, only ε‐WO3 induces a pronounced lattice electronic perturbation that accommodates charge in sub‐conduction band minimum states.
Matteo D'Andria, Meng Yin, Stefan Neuhauser, Vlasis G. Mavrantzas, Ying Chen, Ken Suzuki, Andreas T. Güntner   +6 more
wiley   +1 more source

Strain Gage amplifier

, 2008
The thesis deals about method of gain signals from strain gauge bridges. There are mentioned some signal conditioning methods for bridges amplifiers and charactered their properties. In the next part of this thesis are calculated the amplifier errors for
Kneblík, Adam
core  

Design of a Compact Two-Stage ADC Based on a Nonuniform Flash Architecture for NTC Thermistor Linearization. [PDF]

Sensors (Basel)
Jovanović J.
europepmc   +1 more source