Results 231 to 240 of about 6,851 (300)

Intraoral scanning for implant‐supported complete‐arch fixed dental prostheses (ISCFDPs): Four clinical reports

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Although there are difficulties with using intraoral scans for implant‐supported complete‐arch fixed dental prostheses (ISCFDPs), several commercially available systems have become helpful in simplifying the treatment process in the prosthetic phase.
Toshiki Nagai   +5 more
wiley   +1 more source

Effect of build orientation on the fabrication trueness of additively manufactured implant‐supported complete arch interim fixed prostheses

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Purpose To evaluate how build orientation affects the fabrication trueness of additively manufactured implant‐supported complete arch prostheses by comparing them to subtractively manufactured high‐impact polymer‐based prostheses. Materials and Methods An edentulous maxillary model with four implants at canine and first molar regions ...
Amir H. Nejat   +4 more
wiley   +1 more source

The effects of anodization and instrumentation on titanium abutment surface characteristics and biofilm formation

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Purpose To assess the impact of anodization and instrumentation on titanium abutment surface characteristics (surface roughness and wettability) and biofilm formation (viability and mass). Materials and Methods Titanium discs were obtained from pre‐milled abutment blanks made of titanium‐6aluminum‐7niobium alloy.
Weiqing Liu   +4 more
wiley   +1 more source

Finite element analysis of primary healing implants with different transmucosal designs

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Purpose This study aimed to assess the response of peri‐implant tissues, both hard and soft, to mechanical stress when using a primary healing implant (PHI) with two different transmucosal profiles: concave (Model A) and divergent (Model B). The investigation also sought to observe bone modeling under post‐extraction conditions.
Mario Ceddia   +6 more
wiley   +1 more source

Marginal gap of printed, milled, and heat‐pressed two‐piece polyetheretherketone abutments before and after thermal cycling, and their pull‐off bond strength after thermal cycling

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Purpose To evaluate the marginal gap of two‐piece polyetheretherketone (PEEK) abutments fabricated with different methods, before and after thermal cycling, while also focusing on their pull‐off bond strength. Materials and Methods A two‐piece abutment was virtually designed after digitizing a titanium‐base (Ti‐base) abutment.
Almira Ada Diken Türksayar   +6 more
wiley   +1 more source

Home - About - Disclaimer - Privacy