Results 31 to 40 of about 5,786,389 (144)
Two‐phase ammonia plume behavior in a still room: Jack Rabbit III chamber studies
Abstract This paper describes a new set of 45 laboratory experiments where about 180 g of ammonia was released from pressurized liquefied storage in a still 51.3 m3 chamber (i.e., a small room) and the variations of the ammonia gas concentrations and liquid deposition over a 60 min time period were investigated.
Steven Hanna +2 more
wiley +1 more source
Subcooling in hexadecane emulsions
S.1605-1611When a liquid starts to solidify only when cooled well below its melting temperature, this is called subcooling. From nucleation theory, subcooling is expected to increase for small volumes due to statistics and seed isolation effects.
Hiebler, S. +4 more
core +1 more source
Assessment of Hydrate Prediction Software for MEG–Water–NaCl Systems
ABSTRACT This study evaluates the performance of three industry‐standard simulation tools—Aspen HYSYS (V14), Multiflash (V7.5), and OLGA (V2024.1)—by comparing predicted hydrate dissociation temperatures with experimental data obtained from a PVT sapphire cell.
Carys M. Bloomfield +2 more
wiley +1 more source
High‐Temperature Heat Pump Test Bench with n‐Butane (R‐600) Generating Steam
This work involves building a test bench for a high‐temperature heat pump (HTHP) and analyzing the measurements. The focus is on steam generation using an HTHP to decarbonize process steam demand. The findings indicate that stable steam generation is possible, providing a higher heat transfer coefficient in the heat pump's condenser.
Sebastian Benkert +7 more
wiley +1 more source
A Methodology to Integrate Closed‐Cycle Heat Pumps into Batch Distillation Columns
Batch distillation often cannot use vapor recompression due to contamination risks in food and pharma. This study proposes a design for integrating closed‐loop heat pumps using natural fluids. Results show significant energy savings, offering a sustainable alternative to traditional setups.
Philipp Dorn +5 more
wiley +1 more source
Subcooling in PCM emulsions. Pt.1: Experimental
S.93-99Many phase change materials (PCM) tend to subcool in microscopic geometries, even if they show negligible subcooling in macroscopic geometries. This paper presents an experimental study on subcooling and nucleation in paraffin-in-water emulsions ...
Doetsch, Christian +3 more
core +1 more source
A Short‐Cut Design Approach to Evaluate Reboiler Designs in Vapor Recompression Scenarios
A short‐cut model framework that incorporates mechanical vapor recompression (MVR) requirements into reboiler design is presented, which is particularly beneficial during early process development with limited data or initial feasibility assessments.
Franziska Lais +2 more
wiley +1 more source
The objective of this paper is the comparison of two dedicated subcooling methods, after the gas cooler, in a CO2 transcritical refrigeration system. The use of vapor compression refrigeration with R134a for subcooling is the first method, and the second
Evangelos Bellos, Christos Tzivanidis
core +1 more source
Mechanical vapor recompression integration in distillation is analyzed, focusing on feed preheating and column pressure drop. Binary methanol–water and benzene–toluene separations are studied to identify optimal designs, which are further assessed in a bioethanol vacuum distillation sequence regarding energetic, ecological, and economic performance ...
Thorben Hochhaus +3 more
wiley +1 more source
EventFlow: Real‐time neuromorphic event‐driven classification of two‐phase boiling flow regimes
We present a real‐time flow regime classification framework that integrates neuromorphic event‐driven sensing with deep recurrent neural networks. Unlike traditional frame‐based approaches, our system captures sparse event streams from an event‐based camera, representing only the dynamic brightness changes at the individual pixel level.
Sanghyeon Chang +9 more
wiley +1 more source

