Results 181 to 190 of about 31,905 (257)

Nitride MXenes Beyond Carbides: Bridging the Gap Between Computational Prediction and Experimental Realization

open access: yesAdvanced Functional Materials, EarlyView.
Nitride MXenes remain constrained by a persistent gap between computational prediction and experimental realization. This Review identifies the thermodynamic, kinetic, and chemical barriers limiting their synthesis, critically evaluates emerging fabrication routes, and proposes a multidimensional computational‐experimental framework to accelerate the ...
Naresh Varnakavi, Masoud Soroush
wiley   +1 more source

Photoinduced Interfacial Electronic Modulation in Fe2O3‐BiVO4 Heterostructures for Enhanced Photo‐Assisted Zn‐Air Batteries

open access: yesAdvanced Functional Materials, EarlyView.
Light irradiation activates the Fe2O3‐BiVO4 heterostructure, enabling efficient solar‐electrochemical coupling in zinc‐air batteries. The built‐in electric field drives directional charge separation, guiding photoelectrons toward oxygen reduction sites and accumulating holes for oxygen evolution, thereby reducing polarization and enhancing discharge ...
Yili Liu   +7 more
wiley   +1 more source

Out‐of‐Plane Strain‐Decoupled Architecture for High‐Fill‐Factor Stretchable OLED Displays

open access: yesAdvanced Functional Materials, EarlyView.
A vertically decoupled multilayer SOLED architecture separates emissive pixel islands from deformable interconnects, allowing low‐modulus elastomeric layers to accommodate applied strain and suppress strain transfer to the OLED region. This design, combined with transparent hybrid encapsulation, enables a high fill factor (∼75%), stretchability ...
Young Hyun Son   +2 more
wiley   +1 more source

Biodegradable 3D‐Printable and Coatable Antifouling Composites for Marine Applications

open access: yesAdvanced Functional Materials, EarlyView.
Marine biofouling damages submerged surfaces and raises greenhouse gas emissions. Biodegradable antifouling biocomposites were developed by hot‐mixing beeswax, Tween 80, and calcium stearate or stearic acid. Adjusting the component ratio enables processing via hot‐pressing, 3D‐printing, or dip‐coating.
Gabriele Corigliano   +17 more
wiley   +1 more source

Navigating optimal solar-wind trade-offs under climate change. [PDF]

open access: yesNat Commun
Li J   +5 more
europepmc   +1 more source

Lewis Acid Site Engineering in MOF‐Derived Aluminum Oxide/Carbon Composites for Dechlorination of Waste Plastic Pyrolysis Oil

open access: yesAdvanced Functional Materials, EarlyView.
Controlled carbonization of an Al‐MOF partially decomposes its linkers, exposing coordinatively unsaturated Al centers within an oxide/carbon composite. The resulting Lewis acid sites, rather than surface area, govern organochlorine capture: the composite removes chemically diverse organochlorines from waste plastic pyrolysis oil, outperforms a ...
Seong Cheon Kim   +6 more
wiley   +1 more source

Home - About - Disclaimer - Privacy