Results 61 to 70 of about 44,400 (219)

Non‐Additive Criteria Assessment in Sustainability Evaluation of High Entropy Alloys: A Toxicity‐Weighted Framework

Advanced Engineering Materials, EarlyView.
Sustainability assessment requires methodologies that appropriately distinguish between additive and non‐additive material properties. A toxicity‐weighted scoring system is developed and applied that accounts for the disproportionate influence of highly toxic constituents through nonlinear weighting functions, providing more realistic estimates than ...
Seth Mehalic, Oladele A. Ogunseitan, Julie M. Schoenung   +2 more
wiley   +1 more source

Degradation mechanisms of salt-storage asphalt pavements: molecular dynamics insights into salt-water coupling effects on asphalt and aggregate interface

Frontiers in Materials
Salt-induced asphalt interface failure severely limits the service life of salt-storage snow-melting asphalt pavements. Employing eco-friendly sodium formate as organic salts representative, this study employs interfacial strength tests and molecular ...
Liu Zijian, Liu Zijian, Liu Zijian, Zhao Qiang, Zhao Qiang, Yu Jingyang, Yu Jingyang, Yu Jingyang   +7 more
doaj   +1 more source

Сontrol of Intelligent Transport System in Minsk

Наука и техника, 2018
The paper considers algorithms for searching a maximum traffic volume of road vehicles in a traffic light cycle with a distributed intensity pulse and optimization of shifts under coordinated traffic flow control. Modeling of traffic flows have been made
D. V. Kapskiy, D. V. Navoy, P. A. Pegin
doaj   +1 more source

Fabrication Routes for Ionic Conducting Fiber Strain Sensors

Advanced Engineering Materials, EarlyView.
Ionic conducting fiber strain sensors (ICFSs) offer compliant, textile‐integrable sensing. Thus far, the commercialization of ICFSs has been constrained by fiber fabrication routes. This review provides a fabrication‐centric analysis of ICFSs correlating processing strategies with material properties and scalability.
Leo John Kershaw, Zhanhong Yang, Anne Ladegaard Skov, Magdalena Skowyra   +3 more
wiley   +1 more source

Impact of Hydrogen Incorporation on Electronic and Magnetic Structure of X2CrNi18‐9 Stainless Steel

Advanced Engineering Materials, EarlyView.
Hydrogen uptake in austenitic stainless steel alters both its electronic and magnetic structure. Seebeck measurements reveal hydrogen‐induced shifts in the electronic density of states, while neutron scattering uncovers nanoscale inhomogeneities that grow upon hydrogen incorporation, with the most pronounced effect observed in the PBF as‐built state ...
Torben Tappe, Louis Becker, Gaurav Kanu, Thomas F. Headen, Dirk Honecker, Gabi Schierning, Santiago Benito, Sebastian Weber, Klara Lünser, Sabrina Disch   +9 more
wiley   +1 more source

USE OF THE RAMP METERING SYSTEM AT TWO-LEVEL JUNCTIONS

Вестник СибАДИ, 2019
Introduction. The paper describes the method of increasing the capacity of transport interchanges, providing entry into the city, on the example of Belgorod and through the introduction of traffic light control system - Ramp metering.
A. N. Novikov, I. A. Novikov, A. G. Shevtsova, A. G. Burlutskaya   +3 more
doaj   +1 more source

A comparative study on ITS (intelligent transport system) standardization policies in the U.S. and Europe. [PDF]

Heliyon, 2023
Duan R.
europepmc   +1 more source

All‐in‐One Analog AI Hardware: On‐Chip Training and Inference with Conductive‐Metal‐Oxide/HfOx ReRAM Devices

Advanced Functional Materials, EarlyView.
An all‐in‐one analog AI accelerator is presented, enabling on‐chip training, weight retention, and long‐term inference acceleration. It leverages a BEOL‐integrated CMO/HfOx ReRAM array with low‐voltage operation (<1.5 V), multi‐bit capability over 32 states, low programming noise (10 nS), and near‐ideal weight transfer.
Donato Francesco Falcone, Victoria Clerico, Wooseok Choi, Tommaso Stecconi, Folkert Horst, Laura Bégon‐Lours, Matteo Galetta, Antonio La Porta, Nikhil Garg, Fabien Alibart, Bert Jan Offrein, Valeria Bragaglia   +11 more
wiley   +1 more source

From Food to Power: Hydrogel Thermoelectrics for Ingestible Electronics

Advanced Functional Materials, EarlyView.
We introduce a fully edible thermoelectric–electrochromic platform that harvests heat from food and converts it into a visible color change. N‐type and p‐type hydrogel thermoelectric generators connected in series power anthocyanin‐based electrochromic displays, demonstrating the feasibility of safe, biodegradable, ingestible systems for on‐food ...
Antonia Georgopoulou, Bokeon Kwak, Dario Floreano, Esther Amstad   +3 more
wiley   +1 more source

ON THE ISSUE OF DEVELOPING A MODEL OF A TRANSPORT SYSTEM OF INDIVIDUAL MOVEMENTS WITH MANAGEMENT

Надежность и качество сложных систем
Background. The topic of evaluating the effectiveness of intelligent transport systems is relevant and important today. It exerts control effects on the transport system of the city (agglomeration) and ensures the achievement of the necessary level of ...
Yu.V. Fedyukin, E.I. Minakov, I.E. Agureev, N.I. Khazov, V.M. Chaykovskiy   +4 more
doaj   +1 more source