Results 191 to 200 of about 6,264,854 (417)
Parametric Analysis Using the Finite Element Method to Investigate Prosthetic Interface Stresses for Persons with Trans-tibial Amputation [PDF]
, 1996 A finite element (FE) model of the below-knee residual limb and prosthetic socket was created to investigate the effects of parameter variations on the interface stress distribution during static stance. This model was based upon geometric approximations
Childress, Dudley S. +1 more
core +1 more source
Hydrogel‐Based Capacitive Sensor Model for Ammonium Monitoring in Aquaculture
Advanced Engineering Materials, EarlyView.Traditional techniques for monitoring aquaculture water quality, particularly ammonium levels, harm fish. This work presents a novel capacitive sensor with an ionic hydrogel transducer to monitor ammonium concentration in real time based on the ammonium‐induced hydrogel dissociation and osmotic pressure. Monitoring aquaculture water quality, especially
Mohammad Mirzaee +3 more
wiley +1 more source
Discussion: “Progress Report No. 2 on Tool-Chip Interface Temperatures” (Trigger, K. J., 1949, Trans. ASME, 71, pp. 163–170) [PDF]
, 1949 M. E. Merchant
openalex +1 more source
Advanced Engineering Materials, EarlyView.In this study, exciting new bi‐/multi‐linear elastic behavior of soft elastic composites that accompany the activation of wrinkling in the embedded interfacial layers is analyzed. The new features and performance of these composite materials, including dramatic enhancements in energy storage, can be tailored by the concentration of interfacial layers ...
Narges Kaynia +2 more
wiley +1 more source
Discussion: “A Study of the Effects of Tool Flank Wear on Tool Chip Interface Temperature” (Olberts, D. R., 1959, ASME J. Eng. Ind., 81, pp. 152–157) [PDF]
, 1959 J. R. Roubik
openalex +1 more source
Advanced Engineering Materials, EarlyView.The study presents an efficient simulation approach for the polymer laser powder bed fusion process polymers process, validated with polyamide 12, polyamide 6, and polyetherketoneketone. It shows that inter layer time affects part density, with 90s yielding dense parts.
Claas Bierwisch +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Additive manufacturing of magnesium alloys by laser is difficult because the melting point of the oxide layer is much higher than the evaporation temperature of the metal underneath. Making the oxide layer thinner can solve this problem. Alloying magnesium with strontium makes the oxide layer thinner, especially at 0.5 wt%.
Elmar Jonas Breitbach +8 more
wiley +1 more source
A Case‐Based Reasoning Approach to Model Manufacturing Constraints for Impact Extrusion
Advanced Engineering Materials, EarlyView.A hybrid modeling approach is presented that combines constraint‐based process modeling and case‐based reasoning. The model formalizes manufacturing constraints and integrates simulation data to model complex manufacturing processes. The approach supports manufacturability analysis during product design through an adaptive modeling environment.
Kevin Herrmann +5 more
wiley +1 more source