Results 131 to 140 of about 32,329 (217)

Leveraging ultra-low interfacial tension and liquid-liquid phase separation in embedded 3D bioprinting. [PDF]

open access: yesBiophys Rev (Melville), 2022
Duraivel S   +6 more
europepmc   +1 more source

Modeling Dislocation Cutting of γ′ Precipitates in Ni‐Base Superalloys: Linking Atomistic and Dislocation Dynamics Simulations

open access: yesAdvanced Engineering Materials, EarlyView.
Dislocation cutting of γ′ precipitates in Ni‐based superalloys is investigated by linking atomistic simulations with discrete dislocation dynamics. The critical cutting stress is shown to be governed by the antiphase boundary energy, while line tension effects promote edge‐preferred cutting.
Frédéric Houllé   +9 more
wiley   +1 more source

Comparison of Triply Periodic Minimal Surface Energy Absorbers Under Uniaxial Compressive Loading

open access: yesAdvanced Engineering Materials, EarlyView.
This study investigates LCD 3D printed Triply Periodic Minimal Surface (TPMS) structures as mechanical energy absorbers. By comparing various base designs and layered combinations under uniaxial compression, it identifies that a Diamond‐Gyroid sandwich structure offers superior performance.
Sergej Grednev   +2 more
wiley   +1 more source

Stepwise isolation of diverse metabolic cell populations using sorting by interfacial tension (SIFT). [PDF]

open access: yesLab Chip
Shulman M   +9 more
europepmc   +1 more source

Simulation of Inclusion Particle Motion Behavior under Interfacial Tension in Continuous Casting Mold. [PDF]

open access: yesMaterials (Basel), 2022
Siddiqui MIH   +4 more
europepmc   +1 more source

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

open access: yesAdvanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal   +3 more
wiley   +1 more source

Interfacial tension of bilayer lipid membranes

open access: yesOpen Chemistry, 2012
Petelska Aneta
doaj   +1 more source

Home - About - Disclaimer - Privacy