Advanced Engineering Materials, EarlyView.CT‐based finite element simulations combined with in situ X‐ray computed tomography are used to analyze insert pull‐out in nickel‐coated polymer foams. Despite variations in material parameters, deformation consistently concentrates within a narrow annular region around the insert.
Yannik Bautz +4 more
wiley +1 more source
Parameter-uniform numerical method for a coupled system of singularly perturbed turning point problems with Robin boundary conditions. [PDF]
Sci RepKaranam C, Maroju P.
europepmc +1 more source
Fabrication Routes for Ionic Conducting Fiber Strain Sensors
Advanced Engineering Materials, EarlyView.Ionic conducting fiber strain sensors (ICFSs) offer compliant, textile‐integrable sensing. Thus far, the commercialization of ICFSs has been constrained by fiber fabrication routes. This review provides a fabrication‐centric analysis of ICFSs correlating processing strategies with material properties and scalability.
Leo John Kershaw +3 more
wiley +1 more source
From perceived typicality of in-vehicle stylistic cues to autonomous vehicle acceptance: the roles of perceived behavioral control and trust. [PDF]
Front PsycholPan J, Qin Y, Zhu Y, Chen K, Chen M.
europepmc +1 more source
Rapidly Solidified High‐Strength Invar 36 Prepared by Planar‐Flow Melt Spinning
Advanced Engineering Materials, EarlyView.The Invar 36 alloy was rapidly solidified using the planar‐flow melt‐spinning technique. Ribbon samples with thicknesses ranging from 20 to 160 mm were produced. As the grain size of the ribbon decreased to sub‐micron levels, the hardness increased by more than 2 times.
Bekir Akgül, Mehmet Kul
wiley +1 more source
, 2014 This paper presents time comparison between the use of simplex method and interior point method in solving linear optimization problems. The examination was done towards several linear optimization problems.
Santo, Rochmat Ferry +2 more
core
A streaming, certificate-based reduction for convex hull preservation in planar point sets. [PDF]
PLoS OneCadenas O.
europepmc +1 more source
Feasibility and Limitations of the Advanced Replica Process for Bioactive Glasses
Advanced Engineering Materials, EarlyView.Periodic 3D‐printed Kelvin‐cell templates enable a controlled advanced replica process for fabricating highly porous glass lattices. Across P45K9, 45S5, and 13–93, material‐dependent differences in coating, burnout, and shrinkage lead to distinct strut morphologies, while comparable final porosities of 83%–88% are retained.
Swantje Funk +4 more
wiley +1 more source
An interior-point and decomposition approach to multiple stage stochastic programming [PDF]
There is no abstract of this ...
Zhang, S.
core
Multilevel Impacts of Habitat Fragmentation on Plant Diversity and Structure in Urban Remnant Forests. [PDF]
Ecol EvolZhou L, Zhang B, He M, Guo M, Yang J.
europepmc +1 more source