Results 1 to 10 of about 1,736 (117)
A novel interleaved nonisolated high gain DC–DC boost converter based on voltage multiplier rectifier [PDF]
This article proposes an interleaved DC–DC boost architecture with a voltage multiplier rectifier circuit to achieve superior performance. The design methodology and operational characteristics of the converter are examined for two defined duty cycle ...
Majid Hosseinpour +3 more
doaj +2 more sources
Interleaved step-up soft-switching DC–DC Boost converter without auxiliary switches
A voltage gain interleaved soft switched DC–DC Boost converter without auxiliary switch is proposed in this paper. Step-up characteristics are achieved without using any transformer, coupled inductor, voltage multiplier cell, switched inductor/switched ...
Addy Wahyudie +2 more
exaly +3 more sources
Dynamic Performance Evaluation of Bidirectional Bridgeless Interleaved Totem-Pole Power Factor Correction Boost Converter [PDF]
This study aims to conduct an assessment of the dynamic characteristics of a proposed 6.6 kW bidirectional bridgeless three-leg interleaved totem-pole power factor correction (PFC) boost converter developed for the front-end stage of electric vehicle ...
Hsien-Chie Cheng +5 more
doaj +2 more sources
Multiphase Interleaved Converter Based on Cascaded Non-Inverting Buck-Boost Converter
This paper introduces an interleaved buck-boost converter with reduced power electronics devices count in comparison with the conventional topology. The proposed converter consists of a single buck converter followed by $n$ parallel interleaved boost ...
Bader N. Alajmi +3 more
doaj +1 more source
In this paper, a high step-up DC-DC interleaved boost converter is proposed for renewable sources with low voltages such as photovoltaic module and fuel cell.
Muhammad Yaseen +5 more
doaj +1 more source
FOUR PHASE INTERLEAVED BOOST CONVERTER - ANALYFOUR PHASE INTERLEAVED BOOST CONVERTER - ANALYSIS AND VERIFICATIONSIS AND VERIFICATION [PDF]
This paper deals with an analysis of four phase interleaved DC-DC converter for higher power application in continuous conduction mode. The interleaved topology is widely used due to their advantage as lower input current ripple which means volume ...
Slavomir KASCAK +3 more
doaj +1 more source
Increasing converter power density is a problem of topical interest. This paper discusses an interleaved approach of the efficiency increase in the buck-boost stage of an inverter with unfolding circuit in terms of losses in semiconductors, output ...
Artem Fesenko +5 more
doaj +1 more source
Coupled inductors can effectively optimize the THD, loss, current ripple, and power density of multiphase interleaved totem-pole PFC converters. However, a coupled inductor will also worsen the zero-crossing distortion process.
Han Fu, Shanxu Duan, Yong Li, Qiqi Li
doaj +1 more source
A non‐isolated DC‐DC converter with low voltage stress and high step‐down voltage conversion ratio
This work focuses on a new non‐isolated interleaved DC‐DC converter with very high step‐down voltage conversion ratio. By employing the switched/series capacitor concept, along with the proper component interconnection, the converter features a high step‐
Stylianos P. Syrigos +3 more
doaj +1 more source
A Single-Phase Bidirectional AC/DC Converter for V2G Applications
This paper presents a single-phase bidirectional current-source AC/DC converter for vehicle to grid (V2G) applications. The presented converter consists of a line frequency commutated unfolding bridge and an interleaved buck-boost stage.
Tao Peng +8 more
doaj +1 more source

