Results 31 to 40 of about 79,349 (289)
High-Frequency Power Transformers With Foil Windings: Maximum Interleaving and Optimal Design [PDF]
Foil conductors and primary and secondary interleaving are normally used to minimize winding losses in high frequency transformers used for high-current power applications. However, winding interleaving complicates the transformer assembly, since taps are required to connect the winding sections, and also complicates the transformer design, since it ...
Barrios Rípodas, Ernesto +4 more
openaire +3 more sources
In this article, a new non-isolated interleaved DC–DC converter is proposed to provide a high voltage conversion ratio in renewable energy systems. The converter configuration is composed of a two-phase interleaved boost converter integrating a voltage ...
Shin-Ju Chen +3 more
doaj +1 more source
High Gain Boost Interleaved Converters with Coupled Inductors and with Demagnetizing Circuits
This paper proposes double interleaved boost converters with high voltage gain and with magnetically coupled inductors, while a third coupled winding is used for magnetic flux reset of the core during converter operation.
Michal Frivaldsky +3 more
doaj +1 more source
EXIT-chart aided near-capacity irregular bit-interleaved coded modulation design [PDF]
A near-capacity irregular Bit-Interleaved Coded Modulation based Iterative Decoding (Ir-BICM-ID) aided scheme is proposed. The irregular design of the scheme pervades the three basic components of BICM-ID, namely the encoder, the unity-rate precoder and ...
Tee, Ronald Yee Siong +2 more
core +1 more source
An Interleaved Quadratic High Step-Up DC-DC Converter With Coupled Inductor
A new high step-up DC-DC converter for renewable energy applications is proposed in this paper. Employing an interleaved quadratic structure, two two-winding coupled inductors (CIs), and voltage multiplier cells (VMCs), the proposed converter can provide
Ramin Rahimi +3 more
doaj +1 more source
High leakage inductance in transformers is the main cause of excessive voltage spikes and ringing waveforms in dc-dc converters. Therefore, reducing leakage inductance is important in the design of power electronic devices.
Dody Yunus Putra Siregar +2 more
doaj +1 more source
An interleaved non‐isolated high gain soft switching DC–DC converter with small input current ripple
This article suggests a non‐isolated high step‐up interleaved DC–DC topology for renewable energy applications. Two three‐winding coupled‐inductors along with two voltage multiplier cells are used to enhance the voltage gain significantly.
Sohrab Abbasian +5 more
doaj +1 more source
Radio frequency energy harvesting (RFEH) is one form of renewable energy harvesting currently seeing widespread popularity because many wireless electronic devices can coordinate their communications via RFEH, especially in CMOS technology. For RFEH, the
Yizhi Li +7 more
doaj +1 more source
This paper proposes a novel interleaved ultra‐large gain zero‐voltage switching (ZVS) DC–DC converter for renewable energy systems. By using coupled inductor (CI) and built‐in transformer (BIT), a high‐voltage gain is achieved.
Tohid Nouri
doaj +1 more source
Analysis of Interleaving Effect for Toroidal Type Transformer Windings
An analysis of the interleaving effect for the secondary winding distribution of a toroidal transformer is presented in this paper. The equations to calculate the leakage inductance of the toroidal transformer are derived using MMF diagrams for the different secondary winding distributions.
Kyoung-Gu Shin +2 more
openaire +2 more sources

