Results 251 to 260 of about 10,019 (306)
Transient microstructural evolution of infrared brazed Fe3Al intermetallics using aluminum foil
, 2008 Shiue, R.K.; Wu, S.K.; Lee, Y.L.
core
Strategies for improving ductility of ordered intermetallics
Progress in Natural Science: Materials International, 2016 Ordered intermetallics possess attractive high-temperature properties; however, low ductility and brittle fracture limit their use as engineering materials in many cases.
Zengbao Jiao, Junhua Luan, C T Liu
exaly +2 more sources
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Photoemission of intermetallics
Journal of Magnetism and Magnetic Materials, 1987Abstract Photoemission and spin-resolved threshold photoemission data on magnetic intermetallic compounds as e.g., MnP and NiMnSb are reviewed. New data on PtMnSb(100) are presented and discussed in terms of a calculated band structure. Recent spin- and angle-resolved photoemission data on monolayer films of Gd on Fe(100) have allowed to test the ...
KISKER, E +3 more
openaire +2 more sources
Intermetallic: A Pseudoelement for Catalysis
Accounts of Chemical Research, 2017A clear correlation between electronic structure and CO2 selectivity for steam reforming of methanol (SRM) was obtained with PdZn, PtZn, NiZn, and PdCd intermetallics on the basis of experiments and calculations. In order to rule out the effects of oxide supports, the intermetallic powders were simply prepared by alloying in an arc furnace followed by ...
A. P. Tsai +4 more
openaire +2 more sources
Intermetallics for permanent magnets
IEEE Transactions on Magnetics, 1993Going back as far as 1931, it is shown by the examples MnAl, Fe-Nd, Fe-Nd-B, and Fe(-Ti)-Sm how the history of permanent magnet materials might have evolved differently if hints had been heeded that were discernible long before a particular magnet development actually began.
openaire +1 more source
Oxidation of Some Intermetallic Compounds and Intermetallic Matrix Composites
MRS Proceedings, 1994AbstractOxidation resistance (1000-1400°C) was characterized for intermetallics M2Al, M3Al, M2Cr, and M5Si3 (M=Nb, Nb+Ti), and metal-toughened intermetallic composite systems. Aluminides were poorest in oxidation, and Laves phases were best. Substitution of Ti for Nb was beneficial for each intermetallic. Addition of metal to produce two-phase castings
M. R. Jackson, R. G. Rowe, D. W. Skelly
openaire +1 more source
Interdiffusion in Intermetallics
Metallurgical and Materials Transactions A, 2013Recently, Tiwari and Mehrotra asserted that the vacancy flux in interdiffusion is driven by a vacancy concentration gradient and also that interdiffusion in intermetallics cannot proceed by the six-jump cycle, triple defect, and antistructural bridge mechanisms.
Irina V. Belova, Graeme E. Murch
openaire +1 more source
Philosophical Transactions of the Royal Society of London. Series A: Physical and Engineering Sciences, 1995
Abstract Ordered intermetallic compounds, notably the aluminides of nickel, titanium, iron and niobium, have been under intensive investigation for the past two decades as prospective load-bearing materials for high temperatures, with special emphasis on aerospace applications.
openaire +1 more source
Abstract Ordered intermetallic compounds, notably the aluminides of nickel, titanium, iron and niobium, have been under intensive investigation for the past two decades as prospective load-bearing materials for high temperatures, with special emphasis on aerospace applications.
openaire +1 more source
High‐entropy intermetallics: from alloy design to structural and functional properties
Rare Metals, 2022Y Yang
exaly