Results 61 to 70 of about 2,753,720 (285)

Avrami exponent under transient and heterogeneous nucleation transformation conditions

open access: yes, 2010
The Kolmogorov-Johnson-Mehl-Avrami model for isothermal transformation kinetics is universal under specific assumptions. However, the experimental Avrami exponent deviates from the universal value.
Avrami   +34 more
core   +1 more source

Advanced burner-rig test for oxidation-corrosion resistance evaluation of MCrAlY/superalloys systems [PDF]

open access: yes, 2006
Protective coatings are used on gas turbine components to enable them to survive in engine-operating conditions. This study presents a recently developed cyclic burner-rig test that is used to simulate helicopter engine conditions and to assess the ...
Andrieu, Eric   +3 more
core   +3 more sources

Diffusionless isothermal omega transformation in titanium alloys driven by quenched-in compositional fluctuations

open access: yesPHYSICAL REVIEW MATERIALS, 2019
Masakazu Tane,1,2,* Hiroki Nishiyama,1 Akihiro Umeda,1 Norihiko L. Okamoto,2 Koji Inoue,2 Martin Luckabauer,2 Yasuyoshi Nagai,2 Tohru Sekino,1 Takayoshi Nakano,3 and Tetsu Ichitsubo2 1Institute of Scientific and Industrial Research, Osaka University ...
M. Tane   +9 more
semanticscholar   +1 more source

Investigation of Oxygen‐Free Wetting Behavior of Aluminum on Copper via Molecular Dynamics Simulations and Experiments

open access: yesAdvanced Engineering Materials, EarlyView.
The wettability of aluminum droplets (Al) on different copper substrates (Cu), where liquid Al spreads on solid Cu surfaces to form a liquid–solid interface, is studied numerically and experimentally. The experimental and numerical results show good agreement in the fast‐spreading regime.
Shan Lyu   +8 more
wiley   +1 more source

Effects of Heating Methods on Precipitation Behavior and Nucleation Activation Energy of γ′ Phase in Iron–Nickel-Based Alloy

open access: yesMetals
Electromagnetic induction heating, which converts electromagnetic energy into thermal energy via electron-lattice collisions, and heat conduction heating, which transfers thermal energy through lattice vibrations, both have significant impacts on the ...
Zhengang Yang   +10 more
doaj   +1 more source

Combined Effects of Deformation and Undercooling on Isothermal Bainitic Transformation in an Fe-C-Mn-Si Alloy

open access: yesMetals, 2019
Both ausforming and transformation temperature affect the successive bainitic transformation and microstructure. The individual influence of each case is clear, whereas the combined effects are still unknown. Thermomechanical simulation and metallography
Hang Zou   +4 more
doaj   +1 more source

Vibrational Features of Water at the Low-Density/High-Density Liquid Structural Transformations

open access: yes, 2011
A structural transformation in water upon compression was recently observed at the temperature $T=277$~K in the vicinity of the pressure $p \approx 2\;000$~Atm [R.M. Khusnutdinoff, A.V. Mokshin, J. Non-Cryst. Solids \textbf{357}, 1677 (2011)].
Allen   +43 more
core   +1 more source

Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys

open access: yesAdvanced Engineering Materials, EarlyView.
This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa   +9 more
wiley   +1 more source

Influence of the Isothermal Transformation Temperature on the Structure and Properties of Low-Carbon Steel

open access: yesNauka ta progres transportu
Purpose. The study is aimed at evaluating the effect of the isothermal transformation temperature on the structure and properties of low-carbon steel. Methodology.
I. A. Vakulenko   +5 more
doaj   +1 more source

JMAK model applied on the κ-carbide precipitation in FeMnAlC steels

open access: yesJournal of Materials Research and Technology, 2021
Different lightweight steels alloys have been treated by different isothermal treatments in order to understand the basics of precipitation kinetics of κ-carbide for such class of new steel grades featured by high concentration of Mn and Al.
Carlo Mapelli   +6 more
doaj   +1 more source

Home - About - Disclaimer - Privacy