Results 31 to 40 of about 54,666 (197)

Isothermal and non-isothermal polymerization of a new bone cement

Journal of Materials Science: Materials in Medicine, 1998
A new bone cement based on poly(ethylmethacrylate) (PEMA), hydroxyapatite powder (HA) and n-butylmethacrylate monomer (n-BMA) has been studied using isothermal and non-isothermal polymerization. Methacrylate monomers are highly reactive and release a considerable amount of heat during polymerization.
ABorzacchiello, LAmbrosio, L Nicolais, EJ Harper, KE Tanner, W Bonfield   +5 more
openaire   +2 more sources

Combined Process‐ and Phase‐Field‐Simulation to Predict the Microstructure of Single‐Crystal Ni‐Based Superalloys

Advanced Engineering Materials, EarlyView.
A combined finite element and phase‐field approach predicts the evolution of microstructure during the directional solidification of Ni‐based superalloys. The model reveals how withdrawal rate, temperature gradient, and wall thickness control the dendrite spacing, highlighting the strong effect of surface regions in thin sections where dendrite growth ...
Sean Böhm, André B. Baldissera, Rainer Völkl, Uwe Glatzel   +3 more
wiley   +1 more source

The Isothermal Layer of the Atmosphere [PDF]

Nature, 1909
APART from other considerations, I think that Mr. Craig's contention (NATURE, January 7, p. 281) as to the isothermal layer is disproved by the results of theodolite observations on ballons-sondes. When a balloon is observed, its altitude above the horizon is in general seen to decrease, showing an increase of wind velocity with height. If Mr.
openaire   +5 more sources

On the isothermal kinetics analysis of transformations in metastable systems: combined use of isothermal and non-isothermal calorimetry [PDF]

Philosophical Magazine, 2007
A procedure to optimize the isothermal calorimetric data of very slow transformation processes of metastable systems is proposed. The method uses an experimental baseline to identify the transitory effects due to the equipment. Moreover, the combined use of isothermal and non-isothermal results is shown to be effective to overcome the intrinsic ...
Blázquez Gámez, Javier Sebastián, Millán, Mitchel D., Conde Amiano, Clara Francisca, Conde Amiano, Alejandro, Conde Amiano, Alejandro (Coordinador)   +4 more
openaire   +3 more sources

Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys

Advanced Engineering Materials, EarlyView.
This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa, Aparna Saksena, Alesander Kostka, Pascal Thome, Felicitas Scholz, Alexandre Mussi, Christoph Somsen, Baptiste Gault, Jan Frenzel, Gunther Eggeler   +9 more
wiley   +1 more source

Aplicación de modelos para la generación de la isoterma de adsorción de metano en una muestra de shale y su impacto en el cálculo de reservas

Revista Fuentes El Reventón Energético, 2015
Several adsorption isotherm models were analyzed for the purpose of fi tting the experimental data published by Gasparik et al. (2012) obtained in a methane adsorption experiment on a shale sample from the Posidonea formation in the netherlands.
Cristian Alexis Murillo Martínez, Olga Patricia Ortiz Cancino, Ovidio Andrez Gomez Rodriguez, Samuel Fernando Muñoz Navarro   +3 more
doaj   +1 more source

Time‐Dependent Oxidation and Scale Evolution of a Wrought Co/Ni‐Based Superalloy

Advanced Engineering Materials, EarlyView.
This study shows how a new wrought Co/Ni‐based superalloy resists oxidation at 800 ∘$^\circ$C. The oxide scale changes from rough, fast‐growing spinel to a dense, protective chromia–alumina layer. Atom probe analysis reveals tiny refractory‐rich bubbles at the interface that mark the transition to long‐term, diffusion‐controlled protection ...
Cameron Crabb, Zachary T. Kloenne, Samuel R. Rogers, Chi Hang Dominik Kwok, Mark C. Hardy, Michele S. Conroy, David Dye   +6 more
wiley   +1 more source

Genetic Algorithm Based Nonlinear Optimization of Adsorption Processes

Journal of the Turkish Chemical Society Section B: Chemical Engineering, 2021
In this study, for different adsorption processes, nonlinear isotherm, kinetic model and thermodynamic parameters were calculated using genetic algorithm-based optimization method. Nonlinear equations were directly used as the model parameters can change
Dilek ÖZMEN, Gülşen FİKİR
doaj  

Fostering Innovation: Streamlining Magnetocaloric Materials Research by Digitalization

Advanced Engineering Materials, EarlyView.
Magnetocaloric cooling (MCE) is an environmentally friendly refrigeration method with great potential. Optimizing MCE materials involves the preparation and screening of large quantities of samples, which in turn generates a large amount of data. A digitalization approach is presented that uses ontologies, knowledge graphs, and digital workflows to ...
Simon Bekemeier, Moritz Blum, Luana Caron, Alisa Chirkova, Philipp Cimiano, Basil Ell, Inga Ennen, Michael Feige, Maik Gaerner, Thomas Hilbig, Andreas Hütten, Günter Reiss, Tapas Samanta, Sonja Schöning, Christian Schröder, Lennart Schwan, Chris Taake, Martin Wortmann   +17 more
wiley   +1 more source

Zeolite Waste Characterization and Use as Low-Cost, Ecofriendly, and Sustainable Material for Malachite Green and Methylene Blue Dyes Removal: Box–Behnken Design, Kinetics, and Thermodynamics

Applied Sciences, 2022
This study investigated the potential of 4A zeolite, named4AZW in this work, generated by natural gas dehydration units as solid waste after several treatment cycles, as a low-cost adsorbent to separately remove two cationic dyes, methylene blue (MB) and
Ali Imessaoudene, Sabrina Cheikh, Jean-Claude Bollinger, Lazhar Belkhiri, Ammar Tiri, Abdelkrim Bouzaza, Atef El Jery, Aymen Assadi, Abdeltif Amrane, Lotfi Mouni   +9 more
doaj   +1 more source