Results 71 to 80 of about 71,459 (273)
Burned Gas Characteristics of Laminar Lifted Flame at the Beginning of Stream Heating
Journal of Thermal Science and Technology, 2011 This research experimentally investigates the exhaust gas characteristics of a methane-air lifted-jet flame with elevated stream temperatures up to 450 K. Emission indices of NOx and CO were measured by direct gas sampling using a gas detector tube.
Mitsutomo HIROTA +2 more
doaj +1 more source
ENERGY &ENVIRONMENTAL MATERIALS, EarlyView.This study investigates Spanish broom (Spartium junceum) as a renewable source for electrospun composite membranes in sustainable water purification. MCC and biochar were functionalized with eco‐friendly precursors and nanomaterials (i.e., HNT, β‐CDs) to develop hybrid PVA nanofiber composites.
Giulia Rando +7 more
wiley +1 more source
Prediction and Analysis of Borosilicate Glass Surface Deformation Induced by Flame Jet
MachinesTo address the issues of low processing efficiency, poor forming accuracy, and internal damage in glass material processing, this study proposes the use of flame jet forming.
Biling Wang +4 more
doaj +1 more source
Recent studies on flame stabilization of premixed turbulent gases [PDF]
, 1957 FLAME stabilization is of importance in the practical design of ramjets and afterburners. It has been studied extensively in recent years, particularly with reference to bluff-body flame-holders.
Penner, S. S., Williams, F.
core
ENERGY &ENVIRONMENTAL MATERIALS, EarlyView.Fabrication process of phase change microcapsules using a Pickering emulsion template method and their subsequent applications. The increasing demand for efficient thermal energy storage systems has driven the development of phase change material microcapsules (PCMMs), which provide high energy‐storage density, reversible phase change, and reduced ...
Ziyan Li +4 more
wiley +1 more source
Effect of Multiphase Radiation on Coal Combustion in a Pulverized Coal jet Flame [PDF]
, 2017 The accurate modeling of coal combustion requires detailed radiative heat transfer models for both gaseous combustion products and solid coal particles. A multiphase Monte Carlo ray tracing (MCRT) radiation solver is developed in this work to simulate a ...
Baum +31 more
core +2 more sources
ELECTROPHORESIS, EarlyView.This review provides a comprehensive summary of monoamine neurotransmitter analysis by capillary electrophoresis with amperometric detection. Fundamental principles of amperometric detection, electrode positioning strategies, and approaches to high‐voltage decoupling are described, followed by a critical comparison of electrode materials, selection of ...
Petr Kubáň +3 more
wiley +1 more source
Smoke Point in Co-flow Experiment [PDF]
, 2009 The Smoke Point In Co-flow Experiment (SPICE) determines the point at which gas-jet flames (similar to a butane-lighter flame) begin to emit soot (dark carbonaceous particulate formed inside the flame) in microgravity.
Sunderland, Peter B. +2 more
core +1 more source
Energy Science &Engineering, EarlyView.Tri‐fuel diesel–Calophyllum inophyllum biodiesel–hydrogen operation was tested over 96 points in a diesel engine. Eight performance and emission metrics feed a preference‐agnostic Bootstrapped Empirical Multiobjective Ranking and Selection methodology, revealing load‐blend‐hydrogen windows that increase efficiency, restrain smoke, and expose NOx trade ...
C. Naga Kumar +5 more
wiley +1 more source
Filtered density functions from direct numerical simulation of a reactive jet in cross-flow
, 2010 Direct numerical simulation (DNS) with multi-step hydrogen-air chemical kinetics is used to investigate the nearfield of a flame stabilized above a reactive jet in cross-flow (JICF). JICF configurations are typically used where rapid mixing is desirable;
Chen, J.H. +4 more
core