Results 171 to 180 of about 2,048 (300)
A numerical study of the mechanical properties and rock bridge coalescence of discrete distribution jointed rock masses under uniaxial loading. [PDF]
Huang D, Wei G, Xiao Z, Jin Q.
europepmc +1 more source
Joint orientation significantly affects P‐wave velocity, with the highest velocity at zero‐degree angles, decreasing to 30° as the angle increases. The velocity increases slightly from 30 to 45 degrees but sharply decreases from 45 to 90 degrees. Abstract Determination of the required parameters in different science contexts using the ultrasonic wave ...
Yaghoob Zarei +4 more
wiley +1 more source
Physical modelling of propagation characteristics of blasting stress waves in rock masses with parallel and X-shaped intersecting joints. [PDF]
Deng Z +5 more
europepmc +1 more source
Seismic waves with tensile stress, high amplitude, and low frequency are most likely to trigger block instability and sliding. Blocks with a single sliding surface are more prone to movement than those with multiple constraints, and roof‐positioned blocks are especially vulnerable to slide.
Xiao Wang +4 more
wiley +1 more source
Cement infill shares compressive and shear stresses during loading, while interfacial friction hinders crack propagation and reduces stress concentration, improving the rock's load‐bearing capacity. Failure modes vary with crack inclination. Unfilled specimens show four modes.
Shihao Yuan +4 more
wiley +1 more source
Study on size effect of limestone-concrete composite with different joint inclination angles under uniaxial compression based on the discrete element method. [PDF]
Liu H, Shen M, Du B, Wang J, Chen H.
europepmc +1 more source
The evolution of the temperature field and frozen wall under different fracture conditions was examined by an artificial ground freezing‐based thermal‐hydraulic coupled model. It was observed that fracture inclination affects the interaction extent of freezing pipes and fracture, while phase transition extent is the dominant factor for heat transfer in
Chenyi Zhang +9 more
wiley +1 more source
Experimental study on the structural failure characteristics and load-bearing mechanism of anchored fractured rock mass. [PDF]
Liu M +5 more
europepmc +1 more source
B1 is bord width 1, B2 is bord width 2, L is the pillar length, W is the pillar width, red color and letter A represent the pillars, and white color and number 1 represent excavated areas. Pstress is the average pillar stress; σv is the vertical component of the virgin stress, MPa; and e is the areal extraction ratio. e = B o B o + B P ${\rm{e}}=\frac{{
Tawanda Zvarivadza +4 more
wiley +1 more source
Experimental study on the coupling control of rock blasting vibration and rock fragmentation size. [PDF]
He L +6 more
europepmc +1 more source

