Results 101 to 110 of about 408,462 (265)

Oligoethylene Glycol Side‐Chain Engineering of Y6‐Derived Nonfullerene Acceptors for Thermally Induced Spontaneous Pseudo‐Planar Heterojunction Organic Photodetectors

open access: yesAdvanced Functional Materials, EarlyView.
OEG‐functionalized Y6‐derived acceptors induce thermally driven vertical phase separation, enabling pseudo‐planar heterojunction organic photodetectors. The resulting PM6:YTEG‐4F and PM6:YTEG‐4Cl organic photodetectors suppress dark current density by approximately 260‐fold and 210‐fold, respectively, while maintaining efficient photoresponse ...
Se Jeong Park   +11 more
wiley   +1 more source

Structure‐Guided Balancing of Ambipolar Transport Enables Symmetric Switching in Heterojunction Bilayer Organic Transistor Inverters

open access: yesAdvanced Functional Materials, EarlyView.
Balancing the spatially separated p‐ and n‐type transport pathways in heterojunction‐bilayer OTFTs enables symmetric inverter switching (VM ≈ 0.5VDD), whereas discrete integration of unipolar OTFTs gives polarity‐dependent and resistive responses. ABSTRACT High inverter performance in ambipolar organic electronics requires balanced channel strengths ...
Sohyun Choi   +3 more
wiley   +1 more source

An Adaptive Inhibitory WSe2 Transistor for Retinomorphic In‐Sensor Image Processing

open access: yesAdvanced Functional Materials, EarlyView.
Conventional retinomorphic devices typically require deliberate gate‐bias tuning for each illumination condition. In this paper, we demonstrate an adaptive inhibitory WSe2 transistor that uses photo‐induced regime shift between the subthreshold and accumulation modes to achieve decision‐free, intensity‐adaptive image processing within a single pixel ...
Juhwan Baek   +12 more
wiley   +1 more source

Forward‐Biased Perovskite Photodiodes for In‐Sensor Optical Change Sensing

open access: yesAdvanced Functional Materials, EarlyView.
A forward‐biased perovskite photodiode is introduced as an in‐sensor analog preprocessing unit that uses current balancing between photocurrent and injection current to generate optical changes relative to programmable optical reference levels. The device directly converts reference‐relative optical changes into bipolar current signals, enabling sensor‐
Eungseon Yeon   +14 more
wiley   +1 more source

Hybrid Ferroelectric Tunnel Junctions with Intrinsic Nonlinearity and Self‐Rectification via Interfacial Reconstruction

open access: yesAdvanced Functional Materials, EarlyView.
Rapid thermal annealing reconstructs the BCFO/Nb:STO interface into an atomically thin reconstructed interfacial layer, which reshapes the tunneling barrier and converts a high‐TER ferroelectric tunnel junction into an intrinsically nonlinear, self‐rectifying device.
Hojin Lee   +21 more
wiley   +1 more source

Amphoteric Cu‐Doping Leading to High Thermoelectric Performance in p‐Type Bismuth Antimony Telluride

open access: yesAdvanced Functional Materials, EarlyView.
This study shows that Cu plays two opposite roles in p‐type Bi0.5Sb1.5Te3 depending on the processing route. Under thermodynamic‐equilibrium bulk‐synthesis, Cu mainly occupies cation sites, increases hole concentration, preserves mobility, and slightly reduces lattice heat transport. The best‐performing composition among the investigated series reaches
Moritz Thiem   +15 more
wiley   +1 more source

Out‐of‐Plane Strain‐Decoupled Architecture for High‐Fill‐Factor Stretchable OLED Displays

open access: yesAdvanced Functional Materials, EarlyView.
A vertically decoupled multilayer SOLED architecture separates emissive pixel islands from deformable interconnects, allowing low‐modulus elastomeric layers to accommodate applied strain and suppress strain transfer to the OLED region. This design, combined with transparent hybrid encapsulation, enables a high fill factor (∼75%), stretchability ...
Young Hyun Son   +2 more
wiley   +1 more source

Bioinspired Hydrogels with Broadly Programmable Mechanics for Soft‐Tissue Interfaces

open access: yesAdvanced Functional Materials, EarlyView.
Sea cucumber‐inspired gelatin hydrogels are formed by directional freezing and mechanically programmed through subsequent ionic treatment. Multiscale characterization and modeling link ion‐regulated chain interactions to directional load transfer within the aligned hierarchical architecture.
Youchao Teng   +20 more
wiley   +1 more source

Drop‐on‐Demand Printed Negative Dielectric Anisotropy Liquid Crystal Droplets for Adaptive Complex Beam Manipulation and Assessment

open access: yesAdvanced Functional Materials, EarlyView.
Printed negative‐dielectric‐anisotropy liquid‐crystal droplets enable multidimensional full‐vectorial optical‐field sensing across polarization, phase, and wavelength, while also generating tunable skyrmionic‐like complex optical fields. ABSTRACT Adaptive manipulation of vectorial optical fields is important for optical metrology, imaging, and ...
Jinge Guo   +14 more
wiley   +1 more source

Defect‐Free Transfer Principles for Scalable, Thin Garnet‐Based Hybrid Solid Electrolytes in Solid‐State Batteries

open access: yesAdvanced Functional Materials, EarlyView.
Defect‐free transfer principles enable scalable fabrication of 15 µm‐thin garnet‐based hybrid solid electrolytes. Hansen solubility parameters correlate interfacial compatibility with coating, transfer, and impregnation behavior, guiding rational selection of slurry/substrate, binder/substrate, and binder/polymer electrolyte combinations.
Seul Gi Chu   +8 more
wiley   +1 more source

Home - About - Disclaimer - Privacy