Results 31 to 40 of about 94 (90)

FORMULASI FAKTOR MODIFIKASI KUAT TARIK BELAH UNTUK KUAT GESER BETON TANPA AGREGAT KASAR

open access: yesJMTS: Jurnal Mitra Teknik Sipil
One way to create high strength concrete is to eliminate coarse aggregate from the concrete mixture. The lack of recommendations for the design of concrete without coarse aggregate can cause failures that must be avoided, especially brittle shear failures.
Daniel Christianto   +4 more
openaire   +1 more source

Pengaruh Penambahan Abu Cangkang Keong Bakau Terhadap Kuat Tekan dan Kuat Tarik Belah Beton

open access: yesJournal Dynamic Saint, 2023
Pengurangan faktor air semen (fas) dan penambahan admixture pozzolanic seperti (silicafume) sering digunakan untuk memodifikasi komposisi beton dan mengurangi pori-pori. Di Indonesia penambahan material tambahan pada campuran beton telah banyak digunakan.
openaire   +1 more source

Penambahan Serat Polypropylene Terhadap Kuat Tekan Dan Kuat Tarik Belah Campuran Beton Geopolimer

open access: yesJURNAL TEKNIK SIPIL CENDEKIA (JTSC)
Kebutuhan beton di Indonesia saat ini semakin meningkat, hal pertama yang sering diperhatikan orang adalah emisi gas rumah kaca (karbon dioksida) yang dihasilkan selama produksi semen. Maka salah satu solusinya perlu digunakan bahan lain untuk menggantikan semen portland yang digunakan dalam pembuatan beton.
Habib Ali Maksum   +2 more
openaire   +1 more source

Efek Penambahan Serat Polypropylene terhadap Kuat Tarik Belah Beton Ringan

open access: yesJurnal Komposit
Beton ringan adalah beton beratnya kurang dari 1840 kg/m³. Beton ringan cenderung memiliki kuat tarik yang rendah, dan karena karakteristik agregat ringan yang digunakan, maka dalam perencanaan campuran beton ditambahkan serat untuk meningkatkan kuat tarik dari beton ringan itu sendiri.
Mufti Amir Sultan   +4 more
openaire   +1 more source

Pengaruh Pemakaian Bahan Tambah Limbah Plastik Kemasan Air Mineral Terhadap Kuat Tekan Dan Kuat Tarik Belah Beton

open access: yesDinamika Rekayasa, 2008
This article present result of research of usage plastic waste tidiness of mineral water (liquefied polypropylene) upon which add with variation of plastic waste equal t o 5%; 10% and 15%, examination conducted at 7, 14, 28 and 56 day for the compression
Gandjar Pamuji   +2 more
doaj  

Analisis Kuat Tekan Beton Dengan Penambahan Serat Rooving Pada Beton Non Pasir

open access: yesJurnal Teknik Sipil dan Perencanaan, 2017
This study aims to determine the effect of adding roving fiber on non-sand concrete to compressive strength and tensile strength. The test specimens used in this study, for each type of variable are 3 cylinders of compression test.
Aris Widodo, Muhammad Abdil Basith
doaj  

Kuat Tekan dan Kuat Tarik Belah Beton Polimer Termodifikasi Alami Amylum serta Bahan Tambah Madu

open access: yesG - SMART, 2017
The resesearch used amylum as a modified polymer and honey as its added ingredient. Therewere with 3 compositions with honey, 0%; 0.03%; and 0.3%, and also 6 amylum compositions,0.1%; 0.2%; 0.5%; 1%; 2%; and 5%. The number of specimens with 20 cm in length and 10cm were 270 that were tested for compressive strength, and the number of specimens with ...
Febri Satrio Nugroho   +3 more
openaire   +2 more sources

Kuat Tekan Dan Kuat Tarik Belah Sebagai Nilai Estimasi Kekuatan Sisa Pada Beton Serat Kasa Aluminiumakibat Variasi Suhu

open access: yesDinamika Rekayasa, 2013
This study was aimed to determine influence of temperature variation to the compressive strength and split cylinder strength of aluminium wire-mesh fibre concrete.
Nanang Gunawan Wariyatno   +1 more
doaj  

KAJIAN PENGGUNAAN LUMPUR SIDOARJO SEBAGAI FILLER TERHADAP KARAKTERISTIK SELF COMPACTING CONCRETE

open access: yesJurnal Ilmiah Teknik Sipil, 2019
Semburan lumpur panas di Sidoarjo (Lumpur Sidoarjo/Lusi), adalah peristiwa menyemburnya lumpur panas di lokasi pengeboran Lapindo Brantas. Inc di Dusun Balongnongo, Desa Renokenongo, Kecamatan Porong, Kabupaten Sidoarjo, Jawa Timur.
Angelina Eva Lianasari   +1 more
doaj  

Pengaruh Penambahan Plastik High Density Polyetilene (HDPE) dalam Campuran Hot Rolled Sheet Wearing Course (HRS-WC) terhadap Parameter Marshall, Kuat Tekan dan Kuat Tarik Belah

open access: yesSemesta Teknika, 2018
In this study, plastics High-Density Polyethylene (HDPE) were used as an additional ingredient of asphalt for HRS-WC mixtures by using a variation of the plastic content of 0%, 2%, 4%, 6% to the asphalt weight.
Pepi Nega Akmus
doaj  

Home - About - Disclaimer - Privacy