Results 141 to 150 of about 136,335 (282)

Conditioning Electrical Stimulation for Patients with Moderate or Severe Carpal Tunnel Syndrome: Double Blinded Randomized Controlled Trial

Annals of Neurology, EarlyView.
Objective Carpal tunnel syndrome (CTS) can drastically impair one's ability to work and interferes with activities of daily living. We recently demonstrated that, in rodents, conditioning electrical stimulation (CES) delivered to the nerve 7 days prior to surgery imparts a conditioning lesion‐like effect by accelerating the rate of regeneration along ...
Yusuke Osaki, Jaret L. Olson, Michael J. Morhart, Matthew W. Curran, Douglas W. Zochodne, K. Ming Chan, on behalf of the Central and Northern Alberta Peripheral Nerve Injury Research Consortium, Hollie Power, Adil Ladak, Lindsay Hubenig, Alto Lo, Christine Webber, Karyne Rabey, Andrew Jack, Joe Watt, Mithun Rajshekar, Ellen Lee, Glyn Murgatroyd, Dan Yeung, Kathleen O'Grady   +19 more
wiley   +1 more source

Wearable exoskeleton robot control using radial basis function‐based fixed‐time terminal sliding mode with prescribed performance

Asian Journal of Control, EarlyView.
Abstract This paper tackles the problem of robust and accurate fixed‐time tracking in human–robot interaction and deals with uncertainties. This work introduces a control approach for a wearable exoskeleton designed specifically for rehabilitation tasks.
Mahmoud Abdallah, Yassine Kali, Maarouf Saad, Raouf Fareh, Maamar Bettayeb   +4 more
wiley   +1 more source

Uniform Gas Flow Distribution into Several Partial Flows under Consideration of Closable Outlets

Chemie Ingenieur Technik, EarlyView.
The uniform distribution of a gas flow into several partial flows poses a challenge in various technical fields. This study presents a static flow distributor design that ensures an equal distribution of an inlet gas flow regardless of the flow rate and the number of open outlets.
Nikolas Schmidt, Markus Labus, Peter Wasserscheid, Stefan Will   +3 more
wiley   +1 more source

Modelling of continuous low‐temperature emulsion co‐polymerization in 3D‐printed reactor

The Canadian Journal of Chemical Engineering, EarlyView.
A kinetic model for the emulsion copolymerization of butyl acrylate/styrene at low temperatures is proposed and validated against experiments with a redox initiator system. The model was successfully transferred to a 3D‐printed tubular reactor and conversions of more than 80% and small particles sizes below 40 nm were observed.
Ferel Issa, Andreas Reinbeck, Kristina M. Zentel   +2 more
wiley   +1 more source

Characterization of a two‐phase hybrid flotation column

The Canadian Journal of Chemical Engineering, EarlyView.
Abstract This study explored the performance of a novel hybrid flotation column, which combines the advantages of a mechanically agitated cell with a flotation column and compared the results with a conventional flotation column setup. The experiments were performed in an air/water two‐phase system under varying airflow rates, frother concentrations ...
Pedro Silva Aires, Artin Afacan, Qi Liu, Vinay Prasad   +3 more
wiley   +1 more source

Sustainable Optimization of Emissions and Performance in Hydrogen Port Injection Diesel Engines Through Port Timing and Injection Duration Modulation

Energy Science &Engineering, EarlyView.
Optimizing hydrogen port injection in diesel engines significantly improves efficiency and reduces emissions, demonstrating a sustainable dual‐fuel strategy for cleaner transportation solutions and lower environmental impact. ABSTRACT This study evaluates a single‐cylinder hydrogen port injection (HPFI) Diesel engine by systematically varying the ...
Kaustubh R. Kapadani, Nithyananda B S, Shrishail B. Sollapur, Rajesh K, Ashish M. Dharme, Hemant K, Nagaraj Ashok, Abhijit Bhowmik   +7 more
wiley   +1 more source

A Multiport Network-Based Integrated Sensing System Using Rectangular Cavity Resonators for Volatile Organic Compounds. [PDF]

Sensors (Basel)
Wang H, Huang J.
europepmc   +1 more source

Heat Transfer Performance of Biphilic Surfaces With Diatomite‐Based Composite Coatings in a Closed Thermosyphon System

Heat Transfer, EarlyView.
ABSTRACT This study investigates the thermal performance of innovative biphilic boiling surfaces designed for CPU cooling applications using a two‐phase closed thermosyphon (TPCT) system. The surfaces were fabricated by applying composite coatings—comprising epoxy resin and diatomite particles functionalized with APTES and PFOTS silanes— onto Al1050 ...
José Pereira, Reinaldo Souza, António Moreira, Ana Moita   +3 more
wiley   +1 more source

Metal-organic framework impregnated sponge-based TENG as a binary input device for logic gate simulation and power plant control. [PDF]

Discov Nano
Palakkattiri Krishnan N, Khandelwal G, Chandrasekhar A.   +2 more
europepmc   +1 more source

Artificial Neural Networks for Defining the Operational Parameters of Sand Filters for Irrigation

Irrigation and Drainage, EarlyView.
ABSTRACT The difficulty in defining the working configuration during the operation of sand filters arises from the complexity of the relationships among the variables in the filtration and backwashing processes. The objective was to use artificial neural networks to model the pressure loss and removal efficiency of filtration in a commercial sand ...
Mádilo Lages Vieira Passos, Fábio Ponciano de Deus, Evelise Roman Corbalan Góis Freire, Adriano Valentim Diotto, Michael Silveira Thebaldi   +4 more
wiley   +1 more source