Results 21 to 30 of about 1,374 (210)

Laminar flame speeds of stratified methane, propane, and n-heptane flames [PDF]

open access: yesCombustion and Flame, 2017
Abstract A numerical study on stratified flames of three hydrocarbon fuels, i.e., methane, propane and n-heptane, is conducted using a unsteady, compressible and reacting flow solver ASURF-Parallel. For each fuel, both fuel consumption speeds and flame front propagation speeds of a rich-to-lean stratified flame are compared to those of their ...
Xian Shi, Jyh-Yuan Chen, Yulin Chen
openaire   +1 more source

The Flame Characteristics of Diesel Fuel Blend with Kepuh (Sterculia Foetida) Biodiesel

open access: yesJournal of Mechanical Engineering Science and Technology, 2019
Kepuh biodiesel fuel (sterculia foetida) is an alternative fuel that can be used to replace fossil fuel. Diesel fuel is performed to determine the laminar flame speed of combustion and high flame by adding biodiesel kepuh volume of 10%, 20%, 30%.
Dani Hari Tunggal Prasetiyo   +2 more
doaj   +1 more source

Laminar Burning Speed of Aviation Kerosene at Low Pressures

open access: yesEnergies, 2022
Aero-engine combustors may experience extreme low pressures in the case of an in-flight shutdown, which makes the study of aviation kerosene flame propagation characteristics at low pressures important.
Jian Liu   +4 more
doaj   +1 more source

Tailoring High‐Valent Iron‐Oxo Species Redox via Extended π‐Fe3d–O2p Orbital Overlapping Toward Chemical‐Efficient Water Purification

open access: yesAngewandte Chemie, EarlyView.
We address the long‐standing challenge of reactivity–selectivity trade‐off by precisely tuning the redox properties of Fe(IV), rather than simply accelerating its formation, to enable chemically efficient and low‐emission water treatment. ABSTRACT High‐valent iron oxo species (Fe(IV)) are attractive for wastewater treatment because of their high ...
Hongyu Zhou   +9 more
wiley   +2 more sources

Turbulent Flames Speeds and Laminar Burning Velocities of Dusts using the ISO 1 m3 Dust Explosion Method

open access: yesChemical Engineering Transactions, 2014
The ISO 1 m3 dust explosion vessel was instrumented with thermocouples acting as flame detectors. These were used with methane/air gas explosions to show that the explosion flame was spherical in the constant pressure phase of the explosion and that a ...
H. Sattar   +3 more
doaj   +1 more source

Effect of Initial Pressure upon Laminar Burning Velocity of Propane -Air Mixture [PDF]

open access: yesEngineering and Technology Journal, 2010
The effect of the initial pressure upon the laminar flame speed, for aPropane-air mixture, has been detected practically, for a wide range ofequivalence ratio.
doaj   +1 more source

Effect Of Initial Pressure Upon Laminar Burning Velocity Of Methane-AirMixtures

open access: yesJournal of Engineering, 2010
The effect of the initial pressure upon the laminar flame speed, for a methane-air mixtures, has been detected paractically, for a wide range of equivalence ratio.
محمد ناصر حميد
doaj   +1 more source

Comparative Study on Chemical Kinetics Mechanisms for Methane-Based Fuel Mixtures under Engine-Relevant Conditions

open access: yesEnergies, 2021
The use of natural gas in pure or in a blended form with hydrogen and syngas in spark ignition (SI) engines has received much attention in recent years. They have higher diffusion coefficient and laminar flame speed, a small quenching distance and wider ...
Amin Paykani
doaj   +1 more source

Extrapolation of laminar flame speeds from stretched flames: Role of finite flame thickness [PDF]

open access: yesProceedings of the Combustion Institute, 2017
Abstract Recognizing the persistent inaccuracy of existing linear and nonlinear expressions to extract laminar flame speeds from experimental data of stretched flame speeds, and the essential and independent role of the flame thickness, in addition to the laminar flame speed, in describing the coupled diffusive and reactive response of the laminar ...
Wenkai Liang, Fujia Wu, Chung K. Law
openaire   +1 more source

Conformable Ferrimagnetic Tattoo Electrodes for Plant Electrophysiology

open access: yesAdvanced Materials Technologies, EarlyView.
The newly developed ferrimagnetic tattoo electrode is capable of measuring plant electrophysiological activity outside the Faraday cage. Its ability to adhere without damaging the plant tissue allows long‐term recordings. This premise opens new avenues for in‐field monitoring of plant health through electrophysiology.
Arianna Melis   +7 more
wiley   +1 more source

Home - About - Disclaimer - Privacy