Results 11 to 20 of about 506,000 (289)
Design exploration methodology for ultra thick laminated composites [PDF]
, 2012 Existing test and analytical methods (theoretical and numerical) are normally restricted to thin laminate components, which cannot accurately represent the 3D stress state behaviour of the so called Ultra Thick Laminates (UTL) structures.
Carrasco-Munoz Y Guerra, Jacinto
core +7 more sources
Damage accumulation in hybrid woven fabric composites. [PDF]
Damage accumulation in glass fibre woven reinforced epoxy laminates manufactured from two different fabrics have been investigated under three different loading conditions.
Asaad, Mohammed
core +9 more sources
Influence of the Anisotropy on the Microstructure and Mechanical Properties of Ti/Al Laminated Composites. [PDF]
Materials (Basel), 2020 Anisotropy is the difference in the microstructure or mechanical properties of materials in different directions. Anisotropic behavior occurs in rolled sheets, and this anisotropy is very obvious in laminated composites.
Huang T +7 more
europepmc +2 more sources
Hybrid Sandwich Panels: A Review
International Journal of Applied Mechanics and Engineering, 2020 A high specific stiffness, high specific strength, and tailoring the properties for specific application have attracted the attention of the researchers to work in the field of laminated composites and Sandwich structures.
S.H. Sandeep, C.V. Srinivasa
doaj +1 more source
Journal of Materials Research and Technology, 2022 The Al1060/Al6061-TiCp/Al1060 laminated composites were successfully fabricated by combining powder metallurgy and hot rolling. A subsequent T6 treatment was employed to optimize the mechanical properties of the laminated composites.
H.Y. Sun +7 more
doaj +1 more source
Evaluation of the compressive and anti-penetration properties of Ti-AlTi-Al laminated composites
Advanced Composites Letters, 2020 In order to further improve the mechanical properties of Ti-Al 3 Ti laminated composites, the endothermic semisolid reaction was used to fabricate Ti-Al 3 Ti-Al laminated composites, and the quasi-static compressive test, dynamic compressive test, and ...
Meini Yuan +3 more
doaj +1 more source
Metals, 2021 The Ti–Al3Ti–Al laminated composites with different Al contents were prepared by vacuum hot pressing sintering technology. The effects of Al content on the dynamic mechanical properties of the composites were studied using the combination of Split ...
Jian Ma +4 more
doaj +1 more source
Fracture Behaviors of SiC Particle Filled and Jute Fiber Reinforced Natural Composites
Journal of Natural Fibers, 2022 Today, there is a new trend to substitute sustainable raw materials instead of unsustainable ones in many production-based industries. Natural fiber-reinforced composites have a low resistance to applied loads and chemical effects compared to synthetic ...
H. Ersen Balcıoğlu
doaj +1 more source
Journal of Materials Research and Technology, 2022 Aluminum/zinc laminated composites with different zinc contents (20 and 50 wt%) were fabricated in the form of sheets by using cross-accumulative roll bonding (CARB) process.
Neda Kalantarrashidi +2 more
doaj +1 more source
Research Progress of Metal-Intermetallic Laminated Composites
Journal of Aeronautical Materials, 2018 Metal-intermetallic laminated composites not only retain the high temperature strength of intermetallics, but also possess the high toughness and ductility of metal at room temperature which are gradually becoming the research priorities of domestic and ...
KONG Fantao +4 more
doaj +1 more source