Results 191 to 200 of about 644 (222)
Some of the next articles are maybe not open access.

Bond Strength of Noncontact Tension Lap Splices

ACI Structural Journal, 1996
The subject of transverse spacing between two reinforcing bars lapped in a noncontact or spaced tension splice is addressed in the ACI Building Code (ACI 318-89). The code provisions are based on monotonic tests performed before 1957 of pullout specimens, beam-end specimens, and small-scale beam specimens, where the clear splice-bar spacing was small ...
openaire   +1 more source

Evaluation of failure mechanism in lap splices and role of stirrup confinement using 3D RBSM

Engineering Structures, 2022
Usman Farooq   +2 more
exaly  

RC STRUCTURAL WALLS WITH STAGGERED LAP SPLICES

Lap splices, in both their detailing and placement, are critical to the seismic response of reinforced concrete (RC) walls. Failure of in-situ RC walls associated with lap splices were most recently recorded after earthquakes in Chile (2010), Taiwan (2016) and Turkey (2023).
openaire   +1 more source

Modelling the load-deformation behaviour of lap splices with the Tension Chord Model

Engineering Structures, 2022
Severin Haefliger   +2 more
exaly  

Influence of bar continuity on behaviour of lapped splices

2010
Most Design Codes encourage the staggering of lapped splices in a section, such that a portion of the bars in the cross section remain continuous throughout the lap zone. A penalty on lap length may be imposed if all bars are lapped at one section. In the literature, however, most of test specimens have had all reinforcement lapped at the same section.
METELLI, Giovanni   +2 more
openaire   +1 more source

ANALYSIS OF R/C LAP SPLICES

Journal of Structural and Construction Engineering (Transactions of AIJ), 1996
Toshikatsu ICHINOSE, Kenji MURATA
openaire   +1 more source

Home - About - Disclaimer - Privacy