Results 201 to 210 of about 286,632 (317)

Blade Count and Rotational Speed Sensitivity of Vertical‐Axis Turbines Under Guided Vehicle‐Generated Transient Wakes

open access: yesEnergy Science &Engineering, EarlyView.
Passing vehicles generate short‐duration wakes that can be redirected toward a vertical‐axis turbine. The interaction between wake structure, blade count, and rotational speed governs transient torque production. Low‐solidity configurations combined with tuned rotational speed enhance energy extraction under vehicle‐induced gusts.
Aydin Ulus, Stefan Ilie Moldovan
wiley   +1 more source

Experimental Validation of Large Eddy Simulation as a Benchmark for Reynolds-Averaged Navier-Stokes Flow Modeling in a Magnetically Levitated Blood Pump. [PDF]

open access: yesAnn Biomed Eng
Abeken J   +8 more
europepmc   +1 more source

A study of the turbulent wake of an airfoil in an air stream with a 90° curvature using hot-wire anemometry and large eddy simulation

open access: yes, 2008
This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.The broad aim of the work presented in this thesis is to investigate the wake of an airfoil under the combined effects of streamwise curvature and pressure ...
Farsimadan, Ehsaan
core  

Unsteady Flow Behavior and Radial Force Analysis of a Side Channel Pump Under Different Blade Tip Cutting Angles Using Computational Fluid Dynamics

open access: yesEnergy Science &Engineering, EarlyView.
The Radial Force (RF) distribution under different cutting angles is presented in Figure 1. Generally, the distribution of RF displays divergence across different flow conditions. The pattern of force distribution reveals a total of 24 peaks, which corresponds to the number of blades of the impeller of the SCP.
Kofi Asamoah Adu‐Poku   +3 more
wiley   +1 more source

Comparative Performance Analysis of Various Flat Plate Solar Collectors Incorporating Spiral and Square Arrangement of Circular Type Riser Tube

open access: yesEnergy Science &Engineering, EarlyView.
Three flat‐plate collectors with spiral and square coiled riser tubes were tested and it was found that the spiral type provides the best results with a thermal efficiency of 66.98% for a mass flow rate of 0.4 kg/min. Riser tube geometry is a key factor in optimizing flat‐plate collector output.
Sakhail Islam Biaz   +4 more
wiley   +1 more source

Forced Draught Impact on Externally Venting Flames: An Experimental and Numerical Investigation

open access: yesFire and Materials, EarlyView.
ABSTRACT Wind can significantly influence fire development and spread in urban and forest environments causing fatal consequences for the public, the first responders, and the environment. Wind‐driven fires can have a significant impact on structural fires as wind can increase the fire's intensity, development, and flame spread.
Anoop Subramania Warrier   +5 more
wiley   +1 more source

Home - About - Disclaimer - Privacy