Results 141 to 150 of about 5,089,608 (342)
Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger +2 more
wiley +1 more source
Theory of high-harmonic generation by low-frequency laser fields.
Physical Review A. Atomic, Molecular, and Optical Physics, 1994 M. Lewenstein +4 more
semanticscholar +1 more source
Advanced Engineering Materials, EarlyView.This study investigates laser‐based oxide removal of Cu inserts in oxygen‐free conditions and examines long‐term oxidation kinetics and surface chemistry under different atmospheres via X‐ray photoelectron spectroscopy. Al–Cu compound casting with differently oxidized surfaces is performed, and intermetallic phase formation, morphology, and thermal ...
Timon Steinhoff +9 more
wiley +1 more source
Supercontinuum generation in bulk solid-state material with bursts of femtosecond laser pulses
Scientific ReportsWe report on experimental and numerical investigation of burst-mode supercontinuum generation in sapphire crystal. The experiments were performed using bursts consisting of two 190 fs, 1030 nm pulses with intra-burst repetition rates of 62.5 MHz and 2.5 ...
B. Momgaudis +5 more
doaj +1 more source
Assessing Altered Coating Adhesion on Plasma‐Deoxidized Surfaces Under Oxygen‐Free Conditions
Advanced Engineering Materials, EarlyView.This study demonstrates the effectiveness of atmospheric pressure plasma pretreatment in modifying silicon and stainless steel surfaces to improve adhesion. Argon‐hydrogen plasma increases surface roughness and improves adhesion strength, whereas pure argon results in smoother surfaces and structural changes.
Selina Raumel +6 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The wettability of aluminum droplets (Al) on different copper substrates (Cu), where liquid Al spreads on solid Cu surfaces to form a liquid–solid interface, is studied numerically and experimentally. The experimental and numerical results show good agreement in the fast‐spreading regime.
Shan Lyu +8 more
wiley +1 more source
Topological insulator laser: Experiments
Science, 2018 M. Bandres +7 more
semanticscholar +1 more source
Electrically pumped topological laser with valley edge modes
Nature, 2020 Yongquan Zeng +11 more
semanticscholar +1 more source