Results 91 to 100 of about 153,389 (320)
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Research and Design of Laser Accurate Displacement Measurement System
, 2011 Laser displacement sensor(LDS) displacement measurement is a non-contact measurement with more precision and a wide range of applications.。In this paper, a laser accurate displacement measurement system based on LDS and three-dimensional linear ...
Xiao Gang Wang, Yue Wei Bai, Kai Liu
core +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Optimisation of a self-mixing laser displacement sensor [PDF]
, 2010 Optical Feedback Interferometry, also known as Self-Mixing, results in compact, selfaligned and contact-less sensors. In this phenomenon, a portion of the laser beam is back reflected from the target and enters the active laser cavity to vary its ...
Zabit, Usman, Usman Zabit
core
A simple, low-cost conductive composite material for 3D printing of electronic sensors [PDF]
, 2012 3D printing technology can produce complex objects directly from computer aided digital designs. The technology has traditionally been used by large companies to produce fit and form concept prototypes (‘rapid prototyping’) before production.
David A Hutchins +19 more
core +1 more source
A Workflow to Accelerate Microstructure‐Sensitive Fatigue Life Predictions
Advanced Engineering Materials, EarlyView.This study introduces a workflow to accelerate predictions of microstructure‐sensitive fatigue life. Results from frameworks with varying levels of simplification are benchmarked against published reference results. The analysis reveals a trade‐off between accuracy and model complexity, offering researchers a practical guide for selecting the optimal ...
Luca Loiodice +2 more
wiley +1 more source
Journal of Pharmacological Sciences, 2005 It is well-known that the anticonvulsant drug, phenytoin (PHT), induces gingival overgrowth as a side effect. The mechanism of PHT-induced gingival overgrowth, however, is not well understood.
Yasuka Tamamori +3 more
doaj +1 more source
Metallic micro displacement capacitive sensor fabricated by laser micromachining technology
, 2006 This paper presents design, fabrication and performance testing results of the micro displacement capacitive microsensor fabricated by femtosecond laser machining technology.
Lai, Yongjun +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.Thermomechanical fatigue tests of laser beam powder bed fusion (PBF‐LB) Inconel 718 show that the additively manufactured material reaches almost the lifetimes of conventionally‐rolled material under no‐dwell conditions. Introducing dwell times at the maximum temperature markedly reduces the lifetimes due to pronounced grain boundary sliding associated
Stefan Guth +6 more
wiley +1 more source