Results 101 to 110 of about 485,888 (296)
Advanced Engineering Materials, EarlyView.The documentation of component manufacture has become an essential part of today's production processes, especially for the analysis and optimization of production or component design with regard to structural performance, economic efficiency, and sustainability.
Björn Denker +4 more
wiley +1 more source
Speckle Characterization In Laser Projector Display
, 2012 Speckle phenomena results from when coherent radiation is reflected from a rough surface. Characterizing the speckle strongly depends on the measurement condition and experimental setup. In this paper we report the experimental results produced with different parameters in the setup.
Xu, Meifang +4 more
openaire +2 more sources
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Virtual Display of Wooden Furniture Cultural Relics Based on Laser and CT Scanning Technology
BioResourcesThe 3D reconstruction and virtual display of wooden furniture cultural relics were investigated using laser scanning and CT scanning techniques. The suitability of different 3D reconstruction techniques and virtual display approaches were considered. The
Guiling Zhao +4 more
doaj +2 more sources
Advanced Engineering Materials, EarlyView.The low cycle fatigue life of additive manufactured HAYNES® 282® superalloy was investigated for conventional and high‐productivity processing: samples of the former lasted 1400–1700 cycles, while samples of the latter failed at ~ 1200 cycles, at 760 °C and 1% strain.
Abdul Shaafi Shaikh +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This article demonstrates the successful qualification of a copper–tungsten composite for laser powder bed fusion. The resulting components exhibited high density, high thermal conductivity, and reduced thermal expansion. Heat sinks with complex geometries were successfully manufactured, clearly showcasing the material's potential for additive ...
Simon Rauh +6 more
wiley +1 more source
PhotoniXOptical metasurfaces to perform optical analog spatial differentiation operations and image edge detection processing is a currently hot topic. However, some metasurface differentiators are limited by polarization dependence, narrow operating bandwidth ...
Chen Zhou +9 more
doaj +1 more source
Laser-Inscribed Stress-Induced Birefringence of Sapphire
Nanomaterials, 2019 Birefringence of 3 × 10 − 3 is demonstrated inside cross-sectional regions of 100 μ m, inscribed by axially stretched Bessel-beam-like fs-laser pulses along the c-axis inside sapphire.
Hua Fan +9 more
doaj +1 more source
Duplex Stainless Steel Laser‐Surface Textured: Stability in Brine Solution
Advanced Engineering Materials, EarlyView.Controlled laser‐surface treatment (LST) of duplex DSS2205 steel is performed to increase its stability in brine solution under cyclic electrochemical assays. The superior protection with respect to flat and smooth panels is attributed to the presence of FeCr2O4 as the main protective oxide layer in the LST surface, after corrosion tests. The stability
Mohammad Rezayat +5 more
wiley +1 more source
OLED-Pumped Organic Laser Diode
PhotonicsA theoretical analysis is presented for a recently proposed high-speed µ-OLED optically pumped organic laser. We confirm that for this configuration, the laser threshold is reached at a lower current density than in the case of a direct-electrically ...
Daan Lenstra, Alexis Fischer
doaj +1 more source