Results 11 to 20 of about 1,229,375 (235)
Development and optimisation of two-line planar laser induced fluorescence technique for combustion measurements [PDF]
, 2012 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.This study has focused on development, optimisation and implementation of the 2-line Planar Laser Induced Fluorescence (2-line PLIF) technique for ...
Anbari Attar, Mohammadreza
core +7 more sources
Measurement and modelling of combustion in a spark ignition engine [PDF]
, 1991 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.A study has been conducted into the causes of cycle by cycle variations in combustion within a spark ignition engine, the best measured engine parameter to ...
Brown, Andrew Gavin
core +7 more sources
Flow and combustion in disc and pent-roof SI engines [PDF]
, 2006 Reported in this thesis is a study of combustion in a disc-shaped combustion chamber spark ignition engine, and in-cylinder flow and combustion in an idealised pent-roof spark ignition engine. Both engines were skip fired, to remove residuals and ensure
Murad, Ahmad E. M. A
core +6 more sources
Computational and experimental models of induction flows in spark-ignition engines [PDF]
, 1988 The objective of this thesis is to combine computational flow modelling, flow visualization and point measurements of mean flow and turbulence properties to obtain a better, more detailed, understandýing of the effects of alternative throttling ...
Sanatian, R.
core +7 more sources
Controllable combustion behaviors of the laser-controlled solid propellant
Defence Technology, 2022 Microsatellites have been widely applied in the fields of communication, remote sensing, navigation and science exploration due to its characteristics of low cost, flexible launch mode and short development period.
Bu-ren Duan +7 more
doaj +1 more source
Laser–plasma interactions for fast ignition [PDF]
Nuclear Fusion, 2014 In the electron-driven fast-ignition approach to inertial confinement fusion, petawatt laser pulses are required to generate MeV electrons that deposit several tens of kilojoules in the compressed core of an imploded DT shell. We review recent progress in the understanding of intense laser plasma interactions (LPI) relevant to fast ignition.
A.J. Kemp +7 more
openaire +2 more sources
Study of the length and influencing factors of air plasma ignition time
Open Physics, 2022 When a high-energy laser acts on a film surface, plasma flashes of both the air and film can be generated simultaneously. However, when the conventional plasma flash method is used to identify thin film damage, there is a misjudgment problem caused by ...
Wang Guixia, Su Junhong
doaj +1 more source
Possible explanations for different surface quality in laser cutting with 1 micron and 10 microns beams [PDF]
, 2012 In laser cutting of thick steel sheets, quality difference is observed between cut surfaces obtained with 1 micron and 10 micron laser beams. This paper investigates physical mechanisms for this interesting and important problem of the wavelength ...
Remy Fabbro +3 more
core +1 more source
Computational studies on HCCI engines. [PDF]
, 2010 Emission legislation is changing in an effort to reduce exhaust emissions from the IC engines. Research and development has been focused on improving both spark-ignition and compression ignition engines to make them more efficient.
Correia, Eduardo Rodrigues
core +7 more sources
Experimental investigations into high-altitude relight of a gas turbine [PDF]
, 2008 This thesis describes experiments to investigate high-altitude relight of a lean direct injection (LDI) combustor. The features that make LDI technology less polluting in terms of NOx compared to conventional combustors are expected to impede relight ...
Read, Robert William
core +2 more sources