Results 141 to 150 of about 253 (183)
Some of the next articles are maybe not open access.
Time-Resolved Laser-Induced Incandescence Measurements on Aerosolized Nickel Nanoparticles
The Journal of Physical Chemistry A, 2021This work presents the first quantitative analysis of time-resolved laser-induced incandescence (TiRe-LII) measurements on aerosolized nickel nanoparticles in several gases and over a range of laser fluences. A measurement model composed of spectroscopic and heat transfer submodels is used to recover the particle size distribution parameters and the ...
S. Robinson-Enebeli +2 more
openaire +2 more sources
Quantitative investigation of soot distribution by laser-induced incandescence
Applied Optics, 2000Strategies employed for quantitative measurement by laser-induced incandescence are detailed. Data are obtained for several laminar diffusion flames formed from blended Diesel fuels of known composition. A tomographic procedure is developed to scale the two-dimensional data to soot volume fraction and to correct for the trapping of signal by the soot ...
D J, Bryce, N, Ladommatos, H, Zhao
openaire +2 more sources
LII–lidar: range-resolved backward picosecond laser-induced incandescence
Applied Physics B, 2013A novel concept for remote in situ detection of soot emissions by a combination of laser-induced incandescence (LII) and light detection and ranging (lidar) is presented. A lidar setup based on a picosecond Nd:YAG laser and time-resolved signal detection in the backward direction was used for LII measurements in sooty premixed ethylene–air flames ...
Billy Kaldvee +3 more
openaire +1 more source
Cavity ringdown and laser-induced incandescence measurements of soot
Applied Optics, 1999Currently laser-induced incandescence (LII) is widely used for the measurement of soot volume fraction. A particularly important aspect of the technique that has received less attention, however, is calibration. The applicability of cavity ringdown (CRD) for measurement of soot volume fraction f(v) is assessed, and the calibration of LII by means of ...
Vander Wal, R. L., Ticich, T. M.
openaire +2 more sources
Chapter 6 Time-Resolved Laser-Induced Incandescence
2009Abstract Online characterization of nanoscaled particles is an important issue in basic research, e.g., combustion soot formation and oxidation, and in several different technical applications, e.g., in nanoparticle production reactors or in automotive raw exhaust.
Alfred Leipertz, Roland Sommer
openaire +1 more source
Laser Direct Microfabrication Using Light-Induced Nanoparticle Incandescence
Advanced Photonics Congress, 2012We report the application of nanoparticle incandescence induced by low-power, near infrared focused laser beams to microfabrication. Microstructures have been successfully etched and sintered in polymeric matrices in which microclusters of different nanomaterials were incorporated.
Mathieu Hautefeuille +6 more
openaire +1 more source
Peak soot temperature in laser-induced incandescence measurements
Applied Physics B, 2006In order to understand the processes involved in the laser-induced incandescence (LII) technique, the value of soot temperature at the peak of the incandescence signal has been studied. To this purpose, an absolute two-color LII technique has been applied on ethylene and methane diffusion flames, based on the comparison with a calibrated tungsten ...
De iuliis S +3 more
openaire +2 more sources
Laser-induced incandescence of GaSb/InGaSb surface layers
Optics & Laser Technology, 2018Abstract Laser-induced incandescence (LII) of a surface layer of GaSb/InxGa1−xSb/GaSb (x = 0.1) sandwich heterostructure is investigated in the visible spectral region under irradiation by the third harmonic of radiation of a Q-switched YAG:Nd3+ laser. Within the laser-induced hot spot on the irradiated surface, strong granularity of LII is observed.
M. Kokhan +4 more
openaire +1 more source
Particle identification by laser-induced incandescence in a solid-state laser cavity
Applied Optics, 2003The laser-induced incandescence of a particle of unknown size and composition can be detected simultaneously with the light elastically scattered by the particle, providing information on both the size and composition of the particle. The technique relies on vaporization of the particle; detection of the incandescence signal at the time of vaporization
Michelle, Stephens +2 more
openaire +2 more sources
Laser-induced incandescence characterization of gas turbine exhausts
SPIE Proceedings, 2003Laser-Induced Incandescence studies of graphite aerosols show that great care has to be taken in interpreting Laser-Induced Incandescence (LII) data from gas turbine exhausts. In principle, particle volume fraction, information on particle size, chemical composition, and physical and chemical properties of the exhaust gas is obtainable by LII without ...
John D. Black +3 more
openaire +1 more source