Results 121 to 130 of about 4,724,325 (351)
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Experimental and numerical analysis of the cyclic behaviour of RC beam-column connections with plain reinforcing bars [PDF]
, 2012 The information available in the literature about the cyclic behaviour of reinforced concrete elements with plain reinforcing bars is scarce. As a consequence, the influence of bar slippage in elements with plain bars is not yet comprehensively ...
Costa, A. +3 more
core +1 more source
Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology
Advanced Engineering Materials, EarlyView.We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham +7 more
wiley +1 more source
, 1994 Load-displacement curves from about 200 short-term and laterally loaded nail-plate joints are analysed. The nail-plates are from Gang-Nail Systems, type GNA 20 S. The test specimens and the measuring systems are described. The tests are divided into 32 different series.
Nielsen, Jacob, Rathkjen, Arne
openaire +1 more source
, 2014 Steel framed structures are routinely infilled with masonry or concrete walls. The infill offers in-plane shear re- sistance that adds to the one from the steel frame. However, the stiffness effect on the entire frame's response is usually neglected.
V. Sarhosis +2 more
semanticscholar +1 more source
Advanced Engineering Materials, EarlyView.This study presents an infrared monitoring approach for direct laser interference patterning (DLIP) combined with a convolutional neural network (CNN). Thermal emission data captured during structuring are used to predict surface topography parameters.
Lukas Olawsky +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Analisa Perbandingan Dinding Geser Yang Simetris Dan Tidak Simetris [PDF]
, 2013 Earthquake make a lateral force on the building. Lateral forces in tall building that exerted in the column is big enough, so need a rigid elements structure such as shear walls to reduce the lateral force.
Ninggeding, A. Y. (Aditya) +2 more
core
Young's and shear moduli and Poisson's ratio for elastic media of high and middle symmetry
, 2006 Using bases of fourth rank tensorial bases of complete Voigt's symmetry elaborated by Walpole we obtained expressions for inverse of Young's modulus E, inverse of shear modulus G and Poisson's ratio, which depend on components of the stiffness tensor S ...
Alderson +26 more
core +1 more source
Advanced Engineering Materials, EarlyView.Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller +6 more
wiley +1 more source