Results 151 to 160 of about 3,559 (212)

In‐situ asphaltene capture with iron oxide nanoparticles in steam‐assisted gravity drainage (SAGD) for improved recovery and partial upgrading of bitumen

The Canadian Journal of Chemical Engineering, EarlyView.
Key improvements obtained by incorporating nanoparticles into a lab‐scale SAGD process configuration. The bar plots show enhanced oil recovery, reduced viscosity, and increased asphaltene adsorption in nanoparticle‐assisted scenarios compared with conventional SAGD.
Luis Prada, Saleh S. Baakeem, Mabkhot BinDahbag, M. Daniela Contreras‐Mateus, Jesus Botett, Afif Hethnawi, Nashaat N. Nassar   +6 more
wiley   +1 more source

The First Principal Calculation of the Temperature-Dependent Crystalline Defect Evolution in UN. [PDF]

Materials (Basel)
Lu Y, Sun T, Li Z, Qian Y, Chen C, Yu L, Pan Z, Wang J, Yang K.   +8 more
europepmc   +1 more source

Performance comparison of pressure swing adsorption and amine‐based absorption for synthesis gas purification

The Canadian Journal of Chemical Engineering, EarlyView.
Comparison of PSA and amine‐based absorption for syngas purification shows that PSA offers lower energy intensity, global warming potential, and minimum selling price, making it a more sustainable option. However, absorption achieves higher syngas purity. A GREENSCOPE‐based multi‐criteria assessment guides optimal process selection.
Magno Fonseca Santos, Antonio Esio Bresciani, Rita Maria Brito Alves   +2 more
wiley   +1 more source

Experimental Investigation of Uranium and Iron Condensation from High-Temperature Plasma Conditions. [PDF]

ACS Omega
Weerakkody EN, Dai Z, Rodriguez KE, Burton MA, Rose TP, Koroglu B, Balboni E.   +6 more
europepmc   +1 more source

Green and sustainable synthesis of magnetite from copper slag via citrate complexation for methylene blue dye removal from water

The Canadian Journal of Chemical Engineering, EarlyView.
Abstract This study proposes a novel, green, and sustainable method for synthesizing magnetic iron oxides from metallurgical copper slag (CS), leveraging its iron content as a valuable resource. Iron was extracted via acid leaching using edible citric acid (ECA), forming a citrate–iron complex (CSL), which was subsequently thermally decomposed at 300°C
Melisa Portilla‐Sangabriel, Karen Valencia García, Tania‐Ariadna García‐Mejía, Agileo Hernández‐Gordillo, Rosa‐María Ramírez‐Zamora   +4 more
wiley   +1 more source

Achieving Phase Control of Polymorphic Tungsten Carbide Catalysts. [PDF]

ACS Catal
Perera SMHD, Ciuffetelli E, Porosoff MD.
europepmc   +1 more source

Application of dynamic modelling and model‐based predictive control to enhance a cooling tower

The Canadian Journal of Chemical Engineering, EarlyView.
Model predictive control (MPC) applied to improve the operation of cooling towers. Abstract Model predictive control (MPC) differs from traditional feedback control by making predictions within a time horizon, providing better control actions for the process.
Douglas de Almeida Giardini, Adriana Guglielmi Ranieri Miranda, Wilson Hideki Hirota, Bruno Faccini Santoro, José Ermirio Ferreira de Moraes   +4 more
wiley   +1 more source

Reviewing experimental studies on chemical thermal energy storage in Cementitious composites: report of the RILEM TC 299-TES. [PDF]

Mater Struct
Skevi L, Ke X, Ginestet S, Ouellet-Plamondon C, Gomes F, Cyr M.   +5 more
europepmc   +1 more source

A novel bubbling fluid bed reactor for the autothermal pyrolysis of waste plastics

The Canadian Journal of Chemical Engineering, EarlyView.
Abstract A new pilot‐scale fluidized bed reactor operated under continuous conditions was developed and tested for the thermal pyrolysis of high‐density polyethylene (HDPE). The study focused on assessing the reliability and operability of the system under different operating conditions (400–550°C), while monitoring mass and energy balances, product ...
Khadija Olivia Ogoula Igouwe, Tchini Sévérin Tanoh, Jasmin Blanchard, Inès Esma Achouri, Nicolas Abatzoglou   +4 more
wiley   +1 more source