Results 131 to 140 of about 148,147 (298)

Thermophysical Properties of the Desulphurization Slags With Various CaS and CaO/Al2O3 Ratio

Advanced Engineering Materials, EarlyView.
This article investigates how CaS content and the CaO/Al2O3 ratio influence the thermophysical properties of desulphurization slags. Using experimental measurements and thermodynamic simulations, this study reveals complex effects on viscosity, surface tension, and density, providing new insight into slag structure and phase behavior under ...
Eldar Salpagarov, Matheus Roberto Bellé, Anton Yehorov, Julia Richter, Olena Volkova   +4 more
wiley   +1 more source

Characterization of a Recyclate‐Based MgO‐Steel Composite As‐Sintered Inert Anode Candidate After Exposure to Cryolite Electrolysis

Advanced Engineering Materials, EarlyView.
Carbon‐free inert anodes are essential for decarbonizing aluminum electrolysis. This study investigates a recyclate‐based MgO‐316L steel composite anode tested under galvanostatic Hall–Héroult conditions in cryolite at 1000°C. Microstructural analysis reveals selective MgO fluorination, spinel and oxide layer formation, electrolyte infiltration, and ...
Serhii Yaroshevskyi, Alexander Adamczyk, Nora Brachhold, Gert Schmidt, Jana Hubálková, R. Gumeniuk, Alexandros Charitos, Christos G. Aneziris   +7 more
wiley   +1 more source

Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere

Advanced Engineering Materials, EarlyView.
In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger, Lienhard Wegewitz, Wolfgang Maus‐Friedrichs   +2 more
wiley   +1 more source

Microstructure, dielectric, ferroelectric and piezoelectric properties of NbO3 lead-free ceramics prepared via cold sintering with post-annealing

Journal of Advanced Dielectrics
Via the method of cold sintering with post-annealing, the lead-free ceramics [Formula: see text][Formula: see text][Formula: see text]NbO3 were prepared.
Neng Qin, Xiao-Ming Chen, Xin-Yu Huang, Jia-Jun Lan, Yu-Ding Xu, Li-Na Liu, Han-Li Lian, Peng Liu   +7 more
doaj   +1 more source

Powder Optimization Strategies for Binder Jetting Printing of BaTiO3 and Ba0,6Sr0,4TiO3 Ceramics

Advanced Engineering Materials, EarlyView.
Powder optimization is investigated to enable binder jetting of BaTiO3 and Ba0.6Sr0.4TiO3 ferroelectric ceramics. The antagonistic relationship between flowability and binder compatibility is addressed through binder impregnation of granulated powders and fumed silica addition to fine powders.
Fanny Pruvost, Lionel Presmanes, Soléna Colin, Marie Vidal, Sophie Guillemet‐Fritsch   +4 more
wiley   +1 more source

Ferroelectric Polarization Dependent Piezoelectric Hardening in BiFeO3‐BaTiO3 Lead‐Free Ceramics

Advanced Electronic Materials
The relation between the improvement of mechanical quality factor (Qm) and internal electric field (Ei) generated during the aging process in lead‐free piezoelectric BiFeO3‐BaTiO3 ceramics is investigated for hard piezoelectric application of power ...
Myang Hwan Lee, Hae In Choi, Da Jeong Kim, Ji Su Kim, Sang Woo Lee, Yubin Park, Sang Mo Yang, Tae Kwon Song   +7 more
doaj   +1 more source

Photo-dielectric effect of NaBiBaTiO lead-free ceramics sintered in nitrogen and oxygen atmospheres

Journal of Advanced Dielectrics
The lead-free ceramics Na[Formula: see text]Bi[Formula: see text]Ba[Formula: see text]TiO[Formula: see text] (BNBT) were prepared via a solid-state sintering method, which was sintered in nitrogen (N2) and oxygen (O2) atmospheres, respectively. The photo-
Tian-Feng Xu, Xiao-Ming Chen, Li-Na Liu, Neng Qin, Han-Li Lian   +4 more
doaj   +1 more source

Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V

Advanced Engineering Materials, EarlyView.
Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena, Benjamin Bergmann, Michael Zenger   +2 more
wiley   +1 more source

Spartan Daily, November 17, 2008 [PDF]

, 2008
Volume 131, Issue 42https://scholarworks.sjsu.edu/spartandaily/10526/thumbnail ...
San Jose State University, School of Journalism and Mass Communications
core   +1 more source

Al–Cu Composite Casting of Laser‐Deoxidized Copper: Bonding, Interfacial Chemistry, and Thermal Conductivity

Advanced Engineering Materials, EarlyView.
This study investigates laser‐based oxide removal of Cu inserts in oxygen‐free conditions and examines long‐term oxidation kinetics and surface chemistry under different atmospheres via X‐ray photoelectron spectroscopy. Al–Cu compound casting with differently oxidized surfaces is performed, and intermetallic phase formation, morphology, and thermal ...
Timon Steinhoff, Finn‐Lennard Janthur, Sascha Zimmermann, Sarah Seffer, Jörg Hermsdorf, René Gustus, Ludger Overmeyer, Wolfgang Maus‐Friedrichs, Hans Jürgen Maier, Christian Klose   +9 more
wiley   +1 more source