Results 11 to 20 of about 156,957 (301)
Buildings, 2023 Lead rubber isolation bearings are well-recognized as a common and effective means to mitigate the seismic responses of bridges. However, rubber isolation bearings used in offshore bridges are extremely vulnerable to the action of the alternation of ...
Yanmin Li +3 more
doaj +3 more sources
Buildings, 2023 For improving the seismic isolation effect, traditional rubber isolation bearing provides a smaller horizontal stiffness. However, it is unfavorable for the displacement control of the seismic isolation layer under rare earthquakes.
Jie Huang +4 more
doaj +1 more source
Journal of Low Frequency Noise, Vibration and Active Control, 2020 Seismic response of five-story frame structure supported by lead-rubber bearings isolation system is investigated subjected to near-fault ground motions.
Qiang Rong
doaj +1 more source
Effectiveness of LRB in Curved Bridge Isolation: A Numerical Study
Applied Sciences, 2022 Lead Rubber Bearings (LRBs) represent one of the most widely employed devices for the seismic protection of structures. However, the effectiveness of the same in the case of curved bridges has not been judged well because of the complexity involved in ...
Praveen Kumar Gupta +4 more
doaj +1 more source
Stability analysis of elastomeric bearings in bridge structures
Advances in Bridge Engineering, 2022 Elastomeric bearings (EB) and lead-rubber bearings (LRB) are used in bridge structures to reduce vehicle vibrations, wind loads, and earthquakes. Therefore, studying their stability is crucial to ensuring the stability of the bridge system itself ...
Moussa Leblouba
doaj +1 more source
Bridge construction cost saving from using LRB (Lead Rubber Bearing) in the area prone to earthquake, Kenteng bridge case study [PDF]
E3S Web of Conferences, 2020 There are many ways to reduce the earthquake force excited in the bridge structure, such as the use of Lead Rubber Bearing, Sliding Isolation Pendulum, and Damper/Lock Up Device.
Dhanis Ariono +2 more
doaj +1 more source
Mechanical Model and Seismic Response Analysis of a Track Type Combined Isolation Device
Applied Sciences, 2022 In view of the weak isolation and shock absorption effect of ordinary isolation bearings at present, a new track damping negative-stiffness device was designed based on the principle of negative stiffness.
Guanjie Kong, Ziyu Wang, Youfa Yang
doaj +1 more source
Journal of Traffic and Transportation Engineering (English ed. Online), 2018 Seismic isolation systems designed for extreme events may likely experience low to moderate earthquakes during the design life of the structure rather than the extreme event itself.
Nefize Shaban, Alp Caner
doaj +1 more source
A novel rate-dependent cohesive-zone model combining damage and visco-elasticity [PDF]
, 2013 This is the author’s post-print version of a work that was accepted for publication in Computers & Structures. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control ...
Alfano, G, Musto, M
core +1 more source
Potential Design of Seismic Vulnerable Buildings Incorporating Lead Rubber Bearing
Buildings, 2019 The seismic hazard of vulnerable regions warrants the investigation of new technologies, such as base level isolation by lead rubber bearing (LRB) devices, that can help to mitigate structural damage on seismic prone buildings. The behavior adopting such
Walid A. Al-Kutti +1 more
doaj +1 more source