Results 81 to 90 of about 9,373,613 (338)
Effects of Bulk and Surface Conductivity on the Performance of CdZnTe Pixel Detectors [PDF]
We studied the effects of bulk and surface conductivity on the performance of high-resistivity CdZnTe (CZT) pixel detectors with Pt contacts. We emphasize the difference in mechanisms of the bulk and surface conductivity as indicated by their different ...
Bolotnikov, Aleksey E. +5 more
core +2 more sources
Adaptable Tile‐Based Pneumatic Origami through Structurally Coupled Localized Actuation
This article presents tile‐based pneumatic origami structures with rigid tiles and flexible fabric creases, achieving adaptable properties including morphing shape, selective multistability, and tunable stiffness. Independently pressurized folding bladders at each crease enable structurally coupled localized actuation of origami structures.
Tiantian Li, Jonathan Luntz, Diann Brei
wiley +1 more source
The conductive characteristics of Bi0.9La0.1Fe0.96Mg0.04O3(BLFM) thin film are investigated at various temperatures and a negative differential resistance (NDR) is observed in the thin film, where a leakage current peak occurs upon application of a ...
Amit Kumar +5 more
core +1 more source
Gallium oxide and gadolinium gallium oxide insulators on Si δ-doped GaAs/AlGaAs heterostructures [PDF]
Test devices have been fabricated on two specially grown GaAs/AlGaAs wafers with 10 nm thick gate dielectrics composed of either Ga<sub>2</sub>O<sub>3</sub> or a stack of Ga<sub>2</sub>O<sub>3</sub> and Gd ...
Craven, A.J. +7 more
core +1 more source
Effects of Carbon Nanoparticles on Triboelectro‐Induced Surface Defects
Carbon nanoparticles added to grease modify the electrocontact behavior. The synergy of particle concentration and electric current dominates the surface damage of metals in contact. Electrical surface damage caused by current leakage is a critical challenge in high‐performance applications such as electric vehicle (EV) drivetrains and wind turbine ...
Mohsen Tajedini +6 more
wiley +1 more source
Leakage flow simulation in a specific pump model [PDF]
This paper deals with the influence of leakage flow existing in SHF pump model on the analysis of internal flow behaviour inside the vane diffuser of the pump model performance using both experiments and calculations. PIV measurements have been performed
BAYEUL-LAINE, Annie-Claude +5 more
core +6 more sources
LEAKAGE CHARACTERISTICS OF OPENINGS FOR REACTOR HOUSING COMPONENTS [PDF]
Measurements were made of the air leakage rates through structural components that penetrate semicontainment reactor housing installations. Full- sized test specimens were sealed inside a 10-ft-diameter test sphere, and the leakage rate was measured as a function of pressure for pressure differentials of up to 25 in. of water.
Baurmash, L. +3 more
openaire +2 more sources
High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
Improvement of device characteristics by multiple step implants or introducing a C gettering layer [PDF]
Ion implantation is used for realization of the collector in vertical bipolar transistors in a BiCMOS process. Secondary defects, remaining after annealing the implant damage, can give rise to an increased leakage current and to collector-emitter shorts.
Custer, J.S. +4 more
core +3 more sources
Influence of an Argon/Silane Atmosphere on the Temperature of a Thermal Plasma
The influence of a silane‐doped argon atmosphere on the chemical composition and temperature of a thermal nontransferring argon plasma is investigated using optical emission spectroscopy. As a result of the high amount of free electrons resulting from the stepwise ionization and dissociation of the silane molecule, even a silane addition of 0.01 vol ...
Lena Kreie +4 more
wiley +1 more source

