Results 31 to 40 of about 442,130 (103)
DataSheet1_Source Model for the 2022 Qinghai Menyuan Ms 6.9 Earthquake Based on D-InSAR.docx
On 8 January 2022, an Ms 6.9 earthquake occurred in Menyuan County, Qinghai Province, China. This earthquake ruptured a patch of the Qilian-Haiyuan fault in the northeast margin of the Qinghai-Tibet Plateau.
Feihuang Cao (13042638) +5 more
core +1 more source
The 8 January 2022 Mw6.7 Menyuan earthquake was generated in the transition zone between the western Lenglongling fault and the eastern Tuolaishan fault, both being part of the Qilian–Haiyuan fault system with an important role in the adjustment of the ...
Jihong Liu +6 more
doaj +1 more source
Operational control and protection implications of fault current limitation in distribution networks [PDF]
Rising short-circuit fault current levels is one of the problems associated with the increased presence of distributed generation (DG) in electrical networks.
Blair, S.M. +3 more
core +3 more sources
Paleoearthquakes of the Düzce fault (North Anatolian Fault Zone): Insights for large surface faulting earthquake recurrence [PDF]
Copyright 2008 by the American Geophysical Union.The 12 November 1999 Mw 7.1 earthquake ruptured the Düzce segment of the North Anatolian Fault Zone and produced a ∼40-km-long surface rupture.
D. Pantosti +22 more
core +1 more source
The Lenglongling uplift and its adjacent areas in the eastern end of Qilian Mountains are the areas where the northeastern margin of the Tibetan Plateau and the Alxa Block (ALB) are strongly squeezed and collided with each other.
Wang QingLiang +6 more
core +1 more source
Fault estimation and fault-tolerant control for discrete-time dynamic systems [PDF]
In this paper, a novel discrete-time estimator is proposed, which is employed for simultaneous estimation of system states, and actuator/sensor faults in a discrete-time dynamic system.
Gao, Zhiwei
core +1 more source
Abstract InSAR‐constrained finite fault slip models are often used to characterize fault geometries and slip distributions of large continental earthquakes. A common feature of these models is a decrease in slip near the surface, commonly expressed as a percentage shallow slip deficit (SSD).
É. Gaudreau, E. Nissen, J. Liu
wiley +1 more source
Abstract The Qilian‐Haiyuan fault system is the main tectonic boundary of the northeastern Tibetan Plateau, controlling the regional tectonic deformation and seismic activity. Extensive Sentinel‐1 SAR data (2014–2021) are used to map the regional tectonic deformation, strain distribution, and locking along primary and secondary faults.
Donglin Wu +6 more
wiley +1 more source
Abstract Railway alignment design in earthquake‐prone regions faces many challenges, among which an active fault zone threat is a dominant factor. However, slight attention has been devoted in this field to the complex fault zone risks affecting alignment optimization (AO). To this end, the first‐known AO model that estimates active fault zone risks is
Taoran Song +6 more
wiley +1 more source
The Deformation Response of Hydrological Loading Due To Water Level Changes in Qinghai Lake
Abstract Over the past 18 years, the water level of Qinghai Lake has risen by more than 4 m, resulting in a total mass increase of approximately 22 Gt. This increase may have impacted the surface deformation and fault activity within a 100 km radius of the lake.
Chao Chen +6 more
wiley +1 more source

