Results 41 to 50 of about 5,328 (211)
Influence of coating on the thermal resistance of a Ni-Based superalloy [PDF]
In this paper, the influence of M-CrAlY polycrystalline coating on the thermal fatigue behavior of a Nickel-base superalloy has been investigated. A special device using a rotating bending machine and two thermal sources has been used to perform thermo ...
C. Mabru +6 more
core +3 more sources
We introduce a nucleic acid nanoparticle (NANP) platform designed to be rrecognized by the human innate immune system in a regulated manner. By changing chemical composition while maintaining constant architectural parameters, we identify key determinants of immunorecognition enabling the rational design of NANPs with tunable immune activation profiles
Martin Panigaj +21 more
wiley +1 more source
The highly anisotropic Fermi surface of bismuth results in variations in magnetotransport properties across different crystallographic directions, which can be characterized by studying microcrystals. To avoid the observed surface melting under room temperature Focused Ion Beam (FIB) irradiation, two low‐temperature FIB fabrication methods are proposed
Amaia Sáenz‐Hernández +6 more
wiley +1 more source
Coupling of Length Scales and Atomistic Simulation of MEMS Resonators
We present simulations of the dynamic and temperature dependent behavior of Micro-Electro-Mechanical Systems (MEMS) by utilizing recently developed parallel codes which enable a coupling of length scales.
Broughton, Jeremy Q., Rudd, Robert E.
core +2 more sources
Local Thermal Conductivity Patterning in Rotating Lattice Crystals of Anisotropic Sb2S3
Microscale control of thermal conductivity in Sb2S3 is demonstrated via laser‐induced rotating lattice crystals. Thermal conductivity imaging reveals marked thermal transport anisotropy, with the c axis featuring amorphous‐like transport, whereas in‐plane directions (a, b) exhibit 3.5x and 1.7x larger thermal conductivity.
Eleonora Isotta +13 more
wiley +1 more source
Development of sputtered techniques for thrust chambers, task 1 [PDF]
Filler materials proposed for use in the sputter fabrication regeneratively cooled thrust chambers were evaluated. Low melting castable alloys, CERROBEND.
Hecht, R. J. +2 more
core +1 more source
The Baptist Church in Warren: Rehabilitation and Preservation Report [PDF]
The Baptist Church in Warren is located in the Warren Waterfront Historic National Register District. Warren also has a Voluntary Historic District. Both the National Register Nomination and the Voluntary Historic District have regulations which pertain ...
Bambara, Lauren +4 more
core +1 more source
Precursor Mineral Phases of Forming Mollusk Shell Nacre: A Study of Hydrated Samples
Mineral, organic phase, and water are the essential components in mollusk shell nacre formation. Their interplay is not well understood, because the hydrated material is difficult to observe at high resolution, under close to native conditions. Forming nacre is studied using environmental and cryo‐electron microscopy and hydrated ACC phases, together ...
Anna Kozell +4 more
wiley +1 more source
The influence of defects of the fatigue resistance of butt and girth welds in A106B steel [PDF]
This three-phase study was directed at developing a fitness for service defect acceptance criteria for welds with defect indications. The study focussed on A106 Gr. B steel pipe. The first phase involved a literature search and critical review to develop
Goetz, D. P., Leis, B. N., Scott, P. M.
core +1 more source
USAP 1989 Cruise IV R/V Polar Duke, Cruise Report [PDF]
This is a report for the 1989 R/V Polar Duke scientific cruise, PD IV-89 (also known as PD8904), around the Antarctic Peninsula. The cruise collected single-channel seismic data, piston cores, and heatflow data.National Science Foundation's Office of ...
Lawver, Lawrence A.
core +1 more source

