Results 1 to 10 of about 26,165 (288)
LGM: Mining Frequent Subgraphs from Linear Graphs [PDF]
, 2011 This paper is going to be published in proceedings of 15th Pacific-Asia Conference on Knowledge Discovery and Data Mining (PAKDD2011)
Yasuo Tabei +3 more
openaire +2 more sources
Applied MechanicsThis work presents an analytical homogenization model developed to predict the tensile and bending behavior of double-wall corrugated cardboard. The proposed approach replaces the complex three-dimensional geometry, composed of five paper layers, with an
Mohamed-Fouad Maouche, Mabrouk Hecini
doaj +1 more source
Lake records and LGM climate in China
Chinese Science Bulletin, 2000 Chinese lake status database has provided systematic geological records of much higher lake level and fresher water than today at the LGM from western China. This wet condition was significant contrast with very dry conditions in eastern China. Together with lake studies from Eurasian continents, there was a wet-condition belt from the Mediterranean ...
Ge Yu, Bin Xue, Sumin Wang, Jian Liu
openaire +1 more source
Output of LGM hosing simulations based on AWIESM1
, 2023 Data description: AMOC_coast_fwf0.1_wn0.05_yearly.nc: Yearly AMOC of a hosing experiment based on LGM climate, with 0.1 Sv freshwater input along the Laurentide ice sheet coast. White noise with a magnitude of 0.05 Sv is further added into the freshwater forcing. The length of the simulation is 1050 model years. AMOC_coast_fwf0.2_yearly.nc: Yearly AMOC
Xiaoxu Shi +2 more
openaire +1 more source
Revue des Énergies Renouvelables, 2013 Dans cette étude théorique et expérimentale, nous nous intéressons à l'effet des paramètres de conception sur les performances thermiques notamment la température de sortie lors de l'écoulement d'une lame d'air dans le conduit utile absorbeur, placé dans
H. Karoua +3 more
doaj
Journal of TechniquesThe resistance spot welding (RSW) technique is widely used for joining two or more metal sheets by involving heat generated by electrical resistance. Due to its efficiency and cost-effectiveness, it is commonly utilized in the automotive, aerospace, and
Osamah Sabah Barrak +2 more
doaj +1 more source
Equilibrium line altitudes of alpine glaciers in Alaska suggest Last Glacial Maximum summer temperature was 2–5 °C lower than during the pre-industrial [PDF]
Climate of the PastThe lack of continental ice sheets in Alaska during the Last Glacial Maximum (LGM; 26–19 ka) has long been attributed to extensive aridity in the western Arctic.
C. K. Walcott +5 more
doaj +1 more source
Late Paleolithic of the Maritime Region after LGM
Problems of Archaeology, Ethnography, Anthropology of Siberia and Neighboring Territories, 2021 Paleolithic sites in the Russian Primorye appeared not earlier than 18,000 cal. BP. In the territories to the south and southwest, there are a large number of sites with microblade industries dating back to the time before the beginning of LGM. The largest number of dated sites falls at the beginning of LGM (24,000-20,000 cal. BP).
openaire +1 more source
Annals of West University of Timisoara: PhysicsThis paper constitutes a new technological solution for the exploitation of one of the most important geothermal deposits located in the locality of Biskra (South-east Algeria).
Chettir Abderrahmane +3 more
doaj +1 more source
Study of V-notch fatigue strength based on affected depth approach
Comptes Rendus. MécaniqueIn this work, the Affected Depth (AD) approach is employed to estimate the high cycle fatigue limit of AISI 416 steel weakened by notches. This approach is based on a critical depth parameter identified from the analysis of the stress distribution around
Youssef, Marwa, Nasr, Anouar
doaj +1 more source