Results 221 to 230 of about 24,130 (268)
Some of the next articles are maybe not open access.
Nanostructured Anode Material for Li-Ion Batteries
Advances in Science and Technology, 2010The present paper focuses on a nanostructured SnCo alloy electrochemically prepared by template method in view of its use as anode material alternative to graphite in lithium-ion batteries. The fabrication of SnCo nanowire arrays was carried out by potentiostatic co-deposition of the two metals by using nanostructured anodic alumina membranes as ...
FERRARA, Germano +6 more
openaire +2 more sources
2016
The active elements for negative (anode) electrodes are reviewed here according to the following sequence. First, the carbon anode is considered, since almost all the Li-ion batteries on the market are presently equipped with graphitic carbon. Then the next elements of the Mendeleev table (Si, Ge, …) are considered.
Christian Julien +3 more
openaire +1 more source
The active elements for negative (anode) electrodes are reviewed here according to the following sequence. First, the carbon anode is considered, since almost all the Li-ion batteries on the market are presently equipped with graphitic carbon. Then the next elements of the Mendeleev table (Si, Ge, …) are considered.
Christian Julien +3 more
openaire +1 more source
Electrochemical Li-Ion Batteries Modelisation for EV
ECS Meeting Abstracts, 2016The future development of electric vehicles is linked with their batteries. In parallel of the actual research focused on the development of new materials and increase of batteries performances in terms of energy, power, cost, durability and weight, it is necessary to develop modeling tools.
Falconi, Andrea +3 more
openaire +2 more sources
Introduction to Li-ion Batteries
2016This chapter highlights the importance and principle of Lithium ion batteries (LIBs) along with a concise literature survey highlighting the research trend on the different components of LIBs namely, cathode, anode and electrolyte. The aims of the present study and the thesis outline are given at the end of the chapter.
openaire +1 more source
Nanocarbons in Li-Ion Batteries
2018The ever-increasing demand for advanced power sources with higher energy density and various form factors strongly pushes us to search for new battery materials and structures beyond current state-of-the-art Li-ion batteries (LIBs). Recent progress in nanoscience and nanotechnology suggests opportunities to develop novel electrode materials and ...
Seok-Kyu Cho +2 more
openaire +1 more source
Boostcharging Li-ion batteries: A challenging new charging concept
Journal of Power Sources, 2005Boostcharging is proposed as a new, ultra-fast, recharging algorithm for Li-ion batteries. Characteristic for boostcharging is that close-to-fully discharged batteries can be recharged with very high currents for a short period of time. Cycle life of Li-ion batteries, boostcharged and additionally standard charged to full capacity do not introduce any ...
Notten, P.H.L. +2 more
openaire +2 more sources
An analysis for cooling Li-ion battery modules
2014 IEEE Fourth International Conference on Consumer Electronics Berlin (ICCE-Berlin), 2014This paper discusses the theory and experiments of heating and air cooling of battery modules. Heating mechanism is shown first, and cooling of a single battery is examined. Optimum air flow speed is discussed. Then, similar discussion is made for a battery module of six serial cells.
Yuuki Kitagawa, Lei Lin, Masahiro Fukui
openaire +1 more source
Hysteresis in PDE model of a Li-ion battery
2016 American Control Conference (ACC), 2016Lithium-ion batteries are commonly used to store energy in electric vehicles. Hysteresis is an important phenomenon observed in the response of these batteries. The most common observation for lithium ion batteries is open circuit voltage and these measurements exhibit hysteretic behavior.
Sepideh Afshar +2 more
openaire +1 more source
This concise book, expertly written by a Li-ion battery specialist, provides an overview of the topic in a format and style that is suitable for non-experts and experts alike. The contents cover essential themes like theory, practice, manufacture and safety.
openaire +1 more source
openaire +1 more source