Results 151 to 160 of about 119,086 (310)
Hierarchical MXene‐Derived NTP/C Nanohybrids for Cryogenic Sodium‐Ion Batteries
A hierarchical MXene‐derived NaTi2(PO4)3/C nanohybrid enables efficient sodium‐ion storage down to −40°C by integrating fast ion–electron transport pathways with an ether‐based electrolyte. The system promotes dominant pseudocapacitive behavior and forms a robust inorganic‐rich SEI, collectively mitigating kinetic and interfacial limitations, thereby ...
M. Sai Bhargava Reddy +5 more
wiley +1 more source
An artificial solid electrolyte interphase (SEI) with lithiophilic sites and chemical bonds anchoring lithium polysulfides (LiPSs) has been developed as a potential solution to protect the lithium (Li) metal anode of Lithium−sulfur (Li–S) batteries. This
Wei Lu +9 more
doaj +1 more source
A high‐Zn2+‐transference hydrogel electrolyte of ex‐PDADAM is developed via anion exchange at quaternary ammonium sites, achieving high Zn2+ transference number (0.86), ionic conductivity (8.10 mS cm−1), and toughness (51.25 MJ m−3). Symmetric cells are operated stably for over 2000 h, while flexible pouch cells retain 90.9% capacity after 300 cycles ...
Jung Woo Hong +8 more
wiley +1 more source
Effect of the Electrolyte Amount and Type on the Lithium‐Sulfur Battery Performance
Lithium‐sulfur (Li‐S) batteries are among the most promising next‐generation battery technologies due to their high theoretical specific capacity. Li‐S battery performance is intricately linked to materials and cell design, with electrolyte design ...
Kagan Yuksel +5 more
doaj +1 more source
Co‐delivery of electrosprayed EDOT and oxidant enables bulk oxidative polymerization during layer‐by‐layer fabrication, creating stable, highly conductive 3D PEDOT structures. This Atomized Oxidative Polymerization (AOP) overcomes the surface deposition‐only and matrix‐limited conductivity of conventional Vapor Phase Polymerization (VPP) and PEDOT:PSS ...
Tazdik Patwary Plateau +2 more
wiley +1 more source
Halloysite-derived mesoporous silica with high ionic conductivity improves Li-S battery performance
The slow Li+ transport rate in the thick sulfur cathode of the Li-S battery affects its capacity and cycling performance. Herein, Fe-doped highly ordered mesoporous silica material (Fe-HSBA-15) as a sulfur carrier of the Li-S battery shows high ion ...
Tang, Aidong +10 more
core +1 more source
A printed superparamagnetic nanoparticle‐based flux guide enables the realization of a hysteresis‐free three‐axis magnetic sensor. This innovative architecture efficiently redirects out‐of‐plane fields to planar sensing elements, facilitating simultaneous vector detection without complex reset protocols.
Changyeop Jeon +10 more
wiley +1 more source
The lithium–sulfur (Li–S) battery presents a promising rechargeable energy storage technology for the increasing energy demand in a worldwide range. However, current main challenges in Li–S battery are structural degradation and instability of the solid ...
Zhen Chen (129176) +7 more
core +1 more source
Top‐down organic pillaring expands the interlayer spacing of bulk‐sized MoS2 particles while preserving the bulk morphology. Operando X‐ray diffraction and electrochemical dilatometry show that MoS2‐bulk undergoes solvent co‐intercalation in diglyme electrolyte, causing large structural expansion, while pillared, expanded MoS2 suppresses solvent uptake
Jaehoon Choi +8 more
wiley +1 more source
CuFeS2 is found to induce the formation of intermediate phases, highlighting a strong Cu–Fe synergistic effect during conversion reactions in lithium all‐solid‐state batteries (Li‐SSBs). The integrated reaction pathway effectively suppresses phase separation and accelerates reaction kinetics, leading to enhanced electrochemical reversibility and ...
Changjiang Bai +15 more
wiley +1 more source

