Results 61 to 70 of about 32,156 (264)
Developing an advanced safety device for bridge-type cranes
Introduction. Experimentally revealed disadvantages of domestic complex safety devices in the part of load capacity limitation and parameters registration are described.
A. N. Nazarov, S. D. Ivanov
doaj +1 more source
In MOCVD MoS2 memristors, a current compliance‐regulated Ag filament mechanism is revealed. The filament ruptures spontaneously during volatile switching, while subsequent growth proceeds vertically through the MoS2 layers and then laterally along the van der Waals gaps during nonvolatile switching.
Yuan Fa +19 more
wiley +1 more source
EFFECT OF RESISTANCE TO ROLLING ON THE DYNAMICS OF THE LIFTING MECHANISMS OF THE TRANSPORTING MAC
Purpose. Coefficient of rolling friction in bearings determines the amount of resistance to rotation of rope drums of the lifting mechanisms of transporting machines, which affects the value of the efficiency of such machines and their dynamics ...
V. M. Bohomaz +3 more
doaj +1 more source
Integration of Low‐Voltage Nanoscale MoS2 Memristors on CMOS Microchips
This article presents the first monolithic integration of nanoscale MoS2‐based memristors into the back‐end‐of‐line of foundry‐fabricated CMOS microchips in a one‐transistor‐one‐resistor (1T1R) architecture. The MoS2‐based 1T1R cells exhibit forming‐free, nonvolatile resistive switching with ultra‐low operating voltages, low cycle‐to‐cycle variability ...
Jimin Lee +16 more
wiley +1 more source
Kinetostatical analysis of a lifting mechanism
This article considers the developed vector-matrix method for determining of driving forces and reaction forces in kinematic pairs of multilever linkage with adjustable closed circuit, which allows obtaining of analytical expressions of desired parameters in an explicit form.
E. S Gebel +2 more
openaire +1 more source
ABSTRACT Electronic waste has emerged as a major environmental challenge, driven by the massive consumption and a limited lifetime of modern electronic devices, stimulating the development of sustainable electronics. Here, an all‐biomaterial gelatin‐choline‐citric acid ([Ch][CA]) ionogel is developed as an active binder to realize self‐sintered ...
Lin Guo +10 more
wiley +1 more source
Receptor‐Free Identification of Toxic Gases Enabled by Hygroscopic Aqueous Salt Films
Water as a gas sensor coating sounds impossible—until it stops evaporating. Here, hygroscopic salt solutions (LiCl, LiBr, H3PO4) form non‐drying aqueous films on CNT chemiresistors under ambient air. Gases partition into these liquid layers, sometimes transforming into water, and generate salt‐specific resistance fingerprints across a four‐channel ...
Seongwoo Lee +5 more
wiley +1 more source
Spatially Modulated Morphotropic Phase Boundaries in a Compressively Strained Multiferroic Thin Film
ABSTRACT The coexisting rhombohedral‐like (R′, MA) and tetragonal‐like (T′, MC) monoclinic phases in compressively strained bismuth ferrite thin films exhibit exceptional piezoelectric and magnetic properties. While previous studies have largely focused on probing the morphotropic phase boundaries (MPBs) comprising ordered R′/T′ twins, their self ...
Ting‐Ran Liu +7 more
wiley +1 more source
Ferroelectric tunnel junction devices based on epitaxial undoped ferroelectric HfO2 films demonstrate stable switching endurance of over 106 switching cycles, low write voltages of ±3 V, 16 measured resistance states, and neuromorphic capability.
Markus Hellenbrand +13 more
wiley +1 more source
This study demonstrates that memristors can replace conventional 2T–1C driving circuits with simplified 1T–1 m architectures by exploiting resistance switching. With ultra‐low switching voltages (< ±0.2 V) and multi‐level resistance states, the memristors precisely control the current injected into organic light‐emitting diodes (OLEDs).
Dong Hyun Kim +6 more
wiley +1 more source

