Results 241 to 250 of about 845,775 (285)

Lightning Strike Tests of Composite Connectors [PDF]

open access: closed, 1992
Abstract : Test results are presented on the lightning strike effects on composite and hybrid type multipin aircraft connectors in comparison with the standard all metal connectors. These tests were performed using a unipolar double exponential long duration pulse recommended by the SAE-AE4L committee at peak current levels of 3 kA, 10 KA, 15 kA, and ...
D P Smith, F J Campbell, C D Bond
openaire   +2 more sources

Insulation Reinforcement for Cable Connector of CRH2 Electric Multiple Unit Under Standard Lightning Impulse Voltage

open access: closedIEEE Transactions on Transportation Electrification, 2023
Jianqiao Ma   +3 more
openaire   +2 more sources

Structural design and wind stability analysis of independent lightning rod

Other Conferences, 2022
In order to obtain a wide "field of vision", ATC radar stations are often located in areas with frequent strong winds in mountains and islands, and may be attacked by extreme weather such as typhoons.
G. Wang   +4 more
semanticscholar   +1 more source

Cable current-carrying status analysis and early fault warning method based on temperature information

Measurement science and technology, 2023
Long-term operation of cables and equipment under abnormal currents can cause insulation aging and reduce the service life of the equipment. Identifying the current-carrying status accurately and early detection of potential failures of power cables is ...
Hanrui Yang   +5 more
semanticscholar   +1 more source

Circuit Simulator Based Analysis for Cable Induced Lightning Effects

2020 IEEE International Symposium on Electromagnetic Compatibility & Signal/Power Integrity (EMCSI), 2020
DO-160G and MIL-STD-461G contain requirements related to upset and damage immunity to cable induced lightning transients. The ability to quickly predict the risk of damage and/or upset early in the equipment and system development cycles is instrumental ...
J. G. Kraemer
semanticscholar   +1 more source

Lightning protection system for PC buildings

International Conference on Logic Programming, 2016
Reinforced concrete (RC) structure buildings constructed using precast concrete (PC) employ mechanical joints to connect the main reinforcing bars within columns.
K. Hiruma, Yoshikane Kojima
semanticscholar   +2 more sources

Earth System and Improvement plan for Shield of Cable with Separable Connector

International Conference on Logic Programming, 2018
Separable connector is used for connecting a cable to a switch gear in new energy generation sites because of its compact size. One of terminations of cable shield is not sometimes earthed in order to reduce power loss due to shield current.
Kenichi Seki   +8 more
semanticscholar   +1 more source

Cable elbow connector calibration for switching transients voltage measurements

2014 ICHVE International Conference on High Voltage Engineering and Application, 2014
Measurement of switching transient voltages appearing at various locations of Underground residential distribution (URD) power cables are vital for the online monitoring and diagnostics of cable insulation condition.
B. Pushpanathan, S. Grzybowski
semanticscholar   +1 more source

Capacity of carrying lightning currents in LPS copper cables and connectors experimental verifications

2011 International Symposium on Lightning Protection, 2011
This paper presents the results of a series of tests on patches of bare copper cable, usually used in LPS to check their ability to conduct lightning currents.
Geraldo Francisco Burani   +4 more
openaire   +2 more sources

Fire hazard in EX Zones caused by lightning protection system tested according to EN 62561-1

, 2017
The article presents the results of studies on the effects of lightning current through various types of lightning cross connectors forming a comprehensive lightning protection system.
J. Wiater
semanticscholar   +1 more source

Home - About - Disclaimer - Privacy