Results 31 to 40 of about 1,535,739 (235)
Method for the measurements of the diameter and height of the dome.
, 2020 (A) Infrared image showing the method for the measurements of the diameter and height of the dome. A white arrow indicates an optical coherence tomography scanning line.
Eunhae Shin (8261637) +2 more
core +1 more source
Advanced Healthcare Materials, EarlyView.Dynamic compression enhances mesenchymal stromal cell proliferation in nonwoven PET scaffolds under chondrogenic differentiation conditions and triggers mechanosensitive transcriptional programs associated with extracellular matrix remodeling. These findings highlight the potential of mechanically stimulated PET scaffolds as a promising platform for ...
Graciosa Quelhas Teixeira +8 more
wiley +1 more source
Radiative Thermal Management for Extreme Environments: Mechanisms and Design Strategies
Advanced Materials, EarlyView.In this review, we discuss the fundamental mechanisms of radiative cooling and solar heating, material and structural design strategies, hybrid approaches integrating additional heat transfer pathways, and durability‐oriented designs addressing environmental stresses.
Hyung Rae Kim +5 more
wiley +1 more source
Advanced Materials Technologies, EarlyView.A flexible piezoresistive pressure sensor with gradient toroidal CNT/PDMS microstructures is reported. The hierarchical geometry enables sequential electrode contact, achieving a sensitivity of 256.20 kPa−1 and linear response (R2 = 0.99) over 0–1000 kPa.
Rongmei Wang +8 more
wiley +1 more source
Journal of Magnesium and AlloysThe room-temperature ductility of magnesium (Mg) alloys is fundamentally limited by preferential basal slip activation—a challenge directly addressable through strategic grain orientation tailoring.
Qingshan Yang +6 more
doaj +1 more source
3D‐Printed Corneal Substitutes: Materials, Fabrication, and Preclinical Progress
Advanced Materials Technologies, EarlyView.Successful clinical translation of 3D‐printed corneal substitutes relies on the interplay between the bioink properties, cellular component, and the fabrication process. These factors influence the critical properties of the construct, including optical transparency, mechanical stability, suture retention, that ultimately govern long‐term stromal ...
Shadi Moshayedi +4 more
wiley +1 more source
Advanced Optical Materials, EarlyView.Here we use a template‐assisted self‐assembly approach of metal colloids onto metal films to produce hybrid plasmonic metasurfaces that integrate nanoparticle‐on‐mirror cavities with periodic metal colloid arrays. The resulting coupling between gap plasmons and grating‐coupled surface plasmon polaritons enables programmable hybrid modes with tailored ...
Afroditi Koutsogianni +6 more
wiley +1 more source
, 2021 The initial release of the 2021 version of the dome control software for the Blaauw ...
Jake Noel-Storr, Mick Veldhuis
core +1 more source
Advanced Robotics Research, EarlyView.WorMa is an amphibious undulatory robot that uses Center of Mass redistribution as the sole terrain adaptation mechanism. This mechanism is based on internal fluid mass redistribution through a pump‐driven latex balloon system that creates three profiles: head‐biased, balanced, and tail‐biased.
Daniil Filimonov, Nana Obayashi
wiley +1 more source
Finite element modelling of limiting dome high sheet metal formability test [PDF]
, 2009 Sheet metal forming is a complex process because it involves many stress state and plastic deformation. So analysis in Limiting dome high test is performing to analyze the criteria of sheet metal.
Mohammad Amir, Hashim
core +2 more sources