Results 191 to 200 of about 58,785 (356)

A Non-Linear Distortion Compensation Method for Transmitters and Receivers of LED Visible Light Communications

, 2017
Takaaki Kumagai, Chikamori Takahiro, Shigeru Tomisato, Satoshi Denno, Tatsuo Furuno, Yasuhiro Oda   +5 more
openalex   +1 more source

Three-dimensional soliton-like distortions in flexoelectric nematic liquid crystals: modelling and linear analysis

, 2022
Ashley Earls, M. Carme Calderer
openalex   +1 more source

RAID-Dataset: human responses to affine image distortions and Gaussian noise. [PDF]

Sci Data
Daudén-Oliver P, Agost-Beltran D, Sansano-Sansano E, Montoliu R, Laparra V, Malo J, Martínez-Garcia M.   +6 more
europepmc   +1 more source

Slip Localization Intensification Mediated by Grain Boundary Sliding in a Polycrystalline Nickel‐Based Superalloy

Advanced Engineering Materials, EarlyView.
The temperature dependence of fatigue behavior in nickel‐based superalloys is investigated through high‐resolution measurements of plastic localization. While increasing temperature reduces localization and enhances fatigue performance in René 88DT, Inconel 718 exhibits a sharp degradation at intermediate temperature due to intensified slip ...
M. Calvat, D. Anjaria, I. Woo, C. Bean, D. Texier, J. C. Stinville   +5 more
wiley   +1 more source

A novel distortion-matched anatomical imaging sequence for high-fidelity functional mapping in submillimeter-resolution fMRI. [PDF]

Sci Rep
Yun SD, Pais-Roldán P, Lee J, Shah NJ.
europepmc   +1 more source

Fatigue Crack Initiation and Growth in Nanocrystalline Ni at Multiple Length‐Scales

Advanced Engineering Materials, EarlyView.
Overview of miniaturized in situ SEM fatigue setup and resultant fatigue crack growth data for nanocrystalline Ni. The presented study focuses on the analysis of fatigue crack growth rate (FCGR) in focused ion beam‐notched microcantilevers prepared from nanocrystalline (NC) Ni as a model material.
Igor Moravcik, Alexander Jelinek, Markus Alfreider, Jutta Luksch, Anton Hohenwarter, Florian Schaefer, Christian Motz, Daniel Kiener   +7 more
wiley   +1 more source

An extension of PESQ for assessing the quality of speech degraded by severe time clipping and linear frequency response distortions [PDF]

, 2004
John G. Beerends, J.M. van Vugt
openalex  

Creep‐Induced Microstructural Evolution in an A2‐B2 Superalloy

Advanced Engineering Materials, EarlyView.
A 27.3Ta‐27.3Mo‐27.3Ti‐8Cr‐10Al (at.%) refractory high‐entropy alloy with precipitation‐strengthened A2‐B2 microstructure was studied by creep tests at 1030°C, which demonstrate a transition in deformation mechanisms in the range of 100–150 MPa applied stress. This is associated with changes in dislocation–precipitate interactions. Relevant deformation
Liu Yang, Aparajita Pramanik, Sandipan Sen, Shubhashis Dixit, Marcel Muench, R. J. Vikram, Daniel Schliephake, Yolita M. Eggeler, Ankur Chauhan, Martin Heilmaier, Alexander Kauffmann   +10 more
wiley   +1 more source

System Linearity and Harmonic Distortion Investigation in a Structural Health Monitoring System [PDF]

Technische Universität Braunschweig (TU), Thomas Roloff, Technische Universität Braunschweig (TU), Christian Hühne, Technische Universität Braunschweig (TU), Michael Sinapius   +5 more
openalex   +1 more source

Influence of Test Temperature and Test Frequency on Fatigue Life of Aluminum Alloy EN AW‐2618A

Advanced Engineering Materials, EarlyView.
The influence of test temperature and test frequency on the fatigue life of EN AW‐2618A is investigated. High‐cycle fatigue tests are performed at different test temperatures and frequencies on the 1000 h/230°C overaged state. Both test parameters reduce fatigue life due to time‐dependent damage mechanisms.
Ying Han, Julian M. Rosalie, Jan Radners, Mauro Madia, Philipp von Hartrott, Birgit Skrotzki   +5 more
wiley   +1 more source